Screwdriver PH3 x 150 mm MEGA model 10333 cross‑head (Phillips)

MEGA model 10333 is a cross‑head (Phillips) screwdriver with a PH3 tip and a 150 mm shaft. It is intended for driving and removing PH3 screws in general assembly and maintenance work. The tool combines a matched tip profile and shaft length to reach recessed screw heads while providing adequate torque transfer for common fastening tasks in electrical, carpentry and household applications.

Advantages

The PH3 x 150 mm screwdriver offers a precisely shaped Phillips tip to reduce cam‑out and ensure consistent engagement with PH3 fasteners. The 150 mm shaft allows access to recessed or partially obstructed screws while keeping the handle clear of the work surface. The tool is a compact, single‑tool solution for operations that require this specific tip size and length, simplifying tool selection and storage.

Suitable for

• Driving and removing PH3 screws in electrical installations
• Carpentry and joinery tasks where PH3 fasteners are used
• General household repairs and maintenance requiring a PH3 tip
• Assembly work on fittings and fixtures with recessed Phillips heads

Key specifications

• Tip type: Phillips (cross‑head) PH3
• Shaft length: 150 mm
• Intended use: driving and removing PH3 screws
• Hand tool category: screwdriver

How to use

Select the PH3 x 150 mm screwdriver when the screw head matches the PH3 profile and the shaft length is required to reach the fastener. Insert the PH3 tip fully into the screw recess to ensure correct seating, then apply steady axial pressure while turning the handle to avoid slipping. For tightening, turn clockwise until the screw is secure; for removal, turn counterclockwise. Inspect the tip and screw head for wear before use and replace the tool if the tip is rounded or damaged.

Usage recommendations

Use the PH3 x 150 mm screwdriver for tasks where the PH3 profile is specified and the 150 mm shaft is needed to reach recessed fasteners. Avoid using the tool as a pry bar or lever. When working on electrical systems, follow appropriate safety procedures, including power isolation and insulated tools if required.