Hole saw set MEGA 8-piece for wood, sizes 64–127 mm, model 26408

MEGA 8-piece hole saw set for wood covers diameters from 64 mm to 127 mm and is designed for cutting circular openings in wooden materials. The set contains a sequence of hole saws that allow making openings for pipes, cables, door hardware and other installations. Intended for use with compatible arbors and drills, this kit supports both rough and finish woodworking where controlled circular cuts are required.

Advantages

The set provides a range of commonly used diameters, reducing the need to buy individual saws for different tasks. Each saw is optimized for cutting in wood, offering efficient material removal and consistent hole geometry. The compact kit makes it easy to store and transport between job sites. Using standardized sizes simplifies planning and speeds up installation work.

Suitable for

• Cutting holes for pipe and conduit installation in wooden walls and panels
• Creating openings for door hardware such as locks and handles
• Installing cable grommets and recessed fixtures in furniture and joinery
• General circular cutting tasks in carpentry and renovation projects

Key specifications

• Coverage of diameters: 64 mm, 68 mm, 74 mm, 79 mm, 84 mm, 92 mm, 102 mm, 127 mm
• Material compatibility: designed for wood and wood-based materials
• Set size: 8-piece range covering mid to large diameters for common installation tasks
• Intended drive: compatible with standard drill arbors and power drills (use appropriate arbor)

How to use

Select the hole saw size corresponding to the required opening diameter and mount it on a compatible arbor. Securely tighten the arbor to the drill, mark the center point of the cut on the workpiece, and pilot-drill if necessary. Start drilling at low speed to seat the pilot and then increase speed as appropriate for the workpiece and drill power. Apply steady pressure and allow the saw teeth to cut without forcing; withdraw occasionally to clear chips. After cutting, remove the cut-out disk and deburr the hole if required.

Usage recommendations

Use a drill with sufficient torque and a secure arbor to prevent wobble. For clean edges, use sharp saws and moderate speed; support the workpiece from the back to reduce splintering. Wear eye and hand protection and follow safe drilling practices.