SDS+ masonry drill bit set MEGA 81006 — 6, 10, 8 mm

Set of SDS+ masonry drill bits MEGA 81006 contains three commonly used diameters — 6 mm, 8 mm and 10 mm — engineered for drilling into concrete, brick and other masonry materials. These SDS+ shank bits are intended for use with SDS+ rotary hammers and combine a carbide tip geometry with a flute design that evacuates dust and rubble for stable drilling and accurate centring. The set is suitable for tasks such as anchor installation, fixing fixtures, making through-holes and preparatory work in renovation and construction.

Advantages

The MEGA SDS+ masonry drill bit set offers compatibility with standard SDS+ hammer drills, ensuring secure bit retention and efficient power transfer. Carbide tips provide wear resistance and maintain drilling precision in abrasive masonry. The flute profile reduces clogging and improves debris removal, which helps sustain drilling speed and reduces bit overheating. The three-diameter selection covers common anchor and fastening sizes, allowing faster job setup without changing to non-compatible bits.

Suitable for

• Drilling holes for anchors and anchor bolts in concrete and brick
• Fixing shelves, handrails and fixtures to masonry walls
• Through-holes for cable conduits and plumbing lines
• General renovation and construction site drilling tasks

Key specifications

• Shank type: SDS+ for rotary hammers
• Tip material: tungsten carbide tip for masonry
• Included diameters: 6 mm, 8 mm, 10 mm
• Typical applications: concrete, brick, block and general masonry
• Drill length: standard working lengths suitable for common anchoring tasks (varies by diameter)

How to use

Install the selected SDS+ bit into the rotary hammer according to the tool manufacturer’s instructions until it locks into the chuck. Choose the appropriate diameter based on the fastener or anchor specification. Use hammer-drilling mode for concrete and other hard masonry; apply steady axial pressure without forcing the tool. Periodically withdraw the bit to clear dust and allow the carbide tip to cool, especially during extended drilling. After completing the hole, remove debris with a brush or compressed air before inserting anchors or fasteners.

Usage recommendations

For best results, match drill diameter to the anchor manufacturer’s recommended hole size, use a rotary hammer with adequate power for the chosen bit diameter, and wear appropriate eye, ear and respiratory protection. Replace bits that show excessive tip wear or wobble to maintain hole accuracy and safe operation.