Drill bit MEGA SDS+ 10 mm for concrete model 81011

MEGA SDS+ 10 mm drill bit for concrete model 81011 is a straight-shank carbide-tipped bit designed for use with rotary hammers that accept SDS+ chucks. With a nominal diameter of 10 mm, this drill bit is made for creating standard holes in concrete, masonry and similar mineral materials. Its geometry and construction allow efficient percussive drilling while maintaining hole roundness and dimensional consistency for dowels, anchors and through-holes in construction and renovation works.

Advantages

The MEGA SDS+ 10 mm drill bit features a carbide cutting tip and reinforced flute profile that provide improved wear resistance and controlled dust evacuation during hammer drilling. Compatibility with SDS+ systems ensures secure mounting and optimal energy transfer from the tool to the bit for reliable drilling performance. The bit’s standard 10 mm diameter offers straightforward compatibility with common anchors and fixtures used in building and installation tasks.

Suitable for

• Drilling 10 mm holes in concrete and reinforced concrete
• Creating anchor and dowel holes in masonry
• Renovation and construction installations where standard bore sizes are required
• Use with rotary hammers and SDS+ chucks for percussive drilling

Key specifications

• Diameter: 10 mm
• Shank system: SDS+
• Intended materials: concrete, masonry and similar mineral substrates
• Tip: carbide cutting tip for improved wear resistance
• Application: rotary hammer / percussive drilling

How to use

Install the drill bit into an SDS+ compatible rotary hammer following the tool manufacturer’s instructions until it locks in place. Select the hammer or rotary hammer mode appropriate for concrete, set the correct rotational speed and apply steady axial pressure while allowing the hammer action to do the cutting. Withdraw the bit periodically to clear dust and debris from the hole, and use water only if the tool and bit are rated for wet drilling. After use, clean the bit and store it in a dry place to prevent corrosion.

Usage recommendations

For best results, match the 10 mm hole to the recommended anchor or dowel size and use a rotary hammer with SDS+ chuck rated for concrete work. Wear appropriate personal protective equipment including eye protection, hearing protection and a dust mask when drilling. Replace the bit when cutting edges become worn or if chipping reduces drilling efficiency.