Drill Bit MEGA 10 mm SDS+ model 81016 for rotary hammers and concrete drilling

MEGA 10 mm SDS+ drill bit model 81016 is a purpose-designed masonry bit for use with SDS+ rotary hammers. With a 10 mm working diameter and an SDS+ shank, this drill bit provides a secure connection to compatible hammer drills and is intended for percussion drilling into concrete, brick and other hard building materials. The geometry and material of the cutting head are made for reliable chip removal and steady drilling performance during anchor, conduit and fixture installation tasks.

Advantages

The SDS+ shank ensures firm retention and quick changes in compatible hammer drills, reducing play and improving energy transfer from the tool to the bit. Its 10 mm diameter is suitable for common anchor sizes and small-diameter fixings. The tip and flute design support efficient dust and debris evacuation under percussive load, maintaining consistent drilling speed and reducing the likelihood of jamming. Constructed for use in concrete and masonry, the bit provides predictable hole size and alignment when used with appropriate rotary hammer settings.

Suitable for

• Drilling holes in concrete and reinforced concrete for anchors and dowels
• Installing electrical conduits and plumbing through masonry walls
• Fixing brackets, fixtures and construction fasteners into brick or block
• General-purpose percussion drilling with SDS+ rotary hammers

Key specifications

• Working diameter: 10 mm
• Shank type: SDS+
• Intended materials: concrete, masonry, brick, block
• Typical use: percussion drilling with rotary hammer

How to use

Secure the drill bit into the SDS+ chuck of a compatible rotary hammer following the tool manufacturer's instructions. Select an appropriate percussion/drilling mode and speed for the material. Start drilling at low pressure to position the bit, then apply steady forward pressure while allowing the hammer action to perform the cutting. Withdraw the bit periodically to clear dust and debris from the hole and flute, especially when drilling deep or through reinforced concrete. After use, clean the flutes and store the bit in a dry place to prevent corrosion.

Usage recommendations

Use personal protective equipment such as safety glasses, hearing protection and dust mask when drilling. Match drill diameter and anchor type to the hole size and follow anchor manufacturer instructions. For reinforced concrete, use controlled pressure and appropriate hammer settings to avoid excessive wear on the tip; replace the bit when cutting performance drops noticeably.