Perforator Metabo KHE 2860 QUICK

The Metabo KHE 2860 QUICK is a compact rotary hammer designed for drilling and light chiselling work in concrete, masonry and other construction materials. Equipped with an 880 W motor and SDS Plus chuck, this perforator delivers a balance of power and maneuverability. It supports drilling in concrete up to 28 mm in diameter and features a rated speed of 870 RPM with an idle speed of 1150 RPM. At 3.1 kg and with a 4 m power cord, the tool is suited for overhead and extended-reach work while maintaining stability and control.

Advantages

The tool combines a high-power 880 W motor with a lightweight design, making it easier to handle for prolonged periods without compromising on drilling capacity. The SDS Plus system enables quick and secure bit changes, improving workflow efficiency. Its robust construction ensures reliable performance under frequent use, while the moderate idle and rated speeds provide controlled drilling progress for both precision and aggressive tasks.

Suitable for

• Drilling holes in concrete and masonry for anchors and conduit
• Installing fixtures, sockets and fittings in building works
• Light chiselling and demolition tasks where controlled impact is required
• Renovation and repair work in residential and commercial sites

Key specifications

• Motor power: 880 W
• Maximum drilling diameter in concrete: 28 mm
• Chuck type: SDS Plus
• Rated speed: 870 RPM; Idle speed: 1150 RPM
• Weight: 3.1 kg
• Power cord length: 4 m
• Colour: black, green, red and silver accents

How to use

Before use, inspect the bit and SDS Plus chuck for cleanliness and proper engagement. Select an appropriate drill bit for the material and insert it into the SDS Plus holder until it locks. Secure the workpiece if possible and mark the drilling point. Hold the tool with both hands, align the bit with the mark, and start drilling at low speed to seat the bit, then increase to the working speed. Apply steady, even pressure without forcing the tool; allow the hammer action to perform the cutting. For chiselling, switch to the appropriate mode and use controlled passes. After completing the task, disconnect the power and remove the bit by retracting it from the SDS Plus chuck.

Usage recommendations

Use appropriate personal protective equipment, including eye and ear protection and dust control measures. For extended drilling in reinforced concrete, use carbide-tipped bits and periodically withdraw the bit to clear debris. Avoid excessive lateral force on the bit to prevent premature wear and ensure longer tool life. Store the tool in a dry place and perform regular maintenance according to manufacturer guidance to maintain performance and safety.