Cleaner Spray MICROCHIP Micro Chip Freeze -55 600 ml (CHE1609) for electronics and contact maintenance

Micro Chip Freeze -55 is a 600 ml aerosol cleaning spray from MICROCHIP formulated for maintenance of electronic components and electrical contacts. It is intended for quick removal of contaminants, dirt and light oxidation from printed circuit boards, connectors and contact surfaces without the need to disassemble assemblies. Packaged for field service and workshop use, this spray supports targeted cleaning of sensitive electronics during repair, troubleshooting and preventive maintenance.

Advantages

The formula evaporates rapidly and leaves minimal residue, allowing treated surfaces to return to normal operation soon after application. As an aerosol, it enables precise, localized application to connectors, PCB traces and contact points. The product is suitable for use on a variety of electronic assemblies and contact types where non-abrasive, solvent-based cleaning is required.

Suitable for

• Cleaning printed circuit boards and component leads
• Degreasing and contaminant removal from electrical connectors
• Removing light oxidation from contact surfaces
• Field service and on-site repair of electronic equipment
• Preventive maintenance of control panels and connectors

Key specifications

• Form: aerosol spray, 600 ml can
• Intended use: cleaning of electronic components and electrical contacts
• Application: targeted, non-disassembly cleaning of PCB, connectors and contact surfaces
• Evaporation: fast-drying solvent formulation with low residue
• Packaging: pressurized can suitable for field and workshop use

How to use

Shake the can briefly before use. Apply short bursts of spray from a distance of 10–20 cm to the area to be cleaned, avoiding prolonged soaking. Allow solvents to evaporate completely before powering the device. For confined or sensitive assemblies, use controlled, intermittent sprays and consider using an extension tube for precise application. Follow local safety instructions for handling aerosol solvents and ensure adequate ventilation during use.

Usage recommendations

Test on a small, uncritical area before widespread application to confirm compatibility with plastics, coatings and assemblies. Do not use on energized circuits; disconnect power and discharge capacitors where applicable. Store the aerosol upright in a cool, well-ventilated place away from heat sources and open flame.