Nails MILWAUKEE 15° Ring Shank 3.05 x 25 mm HDG, coil for pneumatic nailer

Coil nails MILWAUKEE 15° ring shank, 3.05 x 25 mm, hot-dip galvanized (HDG) are designed for use with compatible 15° pneumatic coil nailers. These ring shank nails combine a 3.05 mm diameter with a 25 mm length to deliver reliable penetration and improved withdrawal resistance in softwoods, treated timber and engineered wood products. The hot-dip galvanizing provides a protective zinc coating for enhanced corrosion resistance in exterior and humid environments while the coil format enables fast, continuous feeding in production or on-site framing and decking work.

Advantages

Ring shank geometry increases holding power compared with smooth nails, reducing pull-out in structural timber and decking applications. Hot-dip galvanizing offers durable corrosion protection suitable for outdoor exposure and contact with treated lumber. The 15° coil configuration is compatible with a range of pneumatic coil nailers designed for this angle, enabling high-speed, low-interruption fastening. Coil packaging improves jobsite efficiency by reducing reload frequency and waste.

Suitable for

• Framing and structural timber assembly
• Sheathing and subfloor installation
• Decking and exterior woodwork
• General joinery where secure fixation is required

Key specifications

• Nail type: ring shank coil nails
• Shank angle: 15° coil configuration
• Diameter: 3.05 mm
• Length: 25 mm
• Finish: hot-dip galvanized (HDG) zinc coating for corrosion resistance
• Compatibility: designed for pneumatic 15° coil nailers

How to use

Use these nails with a compatible 15° pneumatic coil nailer set to the recommended pressure range for the timber and nail length. Load the coil into the magazine according to the nailer manufacturer’s instructions and confirm proper seating and feed. Position the gun square to the work surface and fire with controlled contact to ensure consistent penetration; if necessary, adjust air pressure or depth-of-drive settings to avoid over- or under-driving. For treated or dense hardwoods, test a few nails first to verify holding and penetration.

Usage recommendations

For best long-term performance in exterior applications, verify local building codes regarding fastener corrosion resistance and use additional corrosion protection or stainless alternatives where required. Store coils in a dry place to maintain the galvanized coating and inspect nails for proper coil integrity before loading.