Router Bit MILWAUKEE S12 Straight HW laminated 19 mm cutting length, 100 mm total length, 1 pc

The Milwaukee S12 Straight HW router bit is engineered for working with laminated materials. It features a carbide (HW) cutting head with a 19 mm cutting length and a 100 mm total length. Supplied as a single piece, this straight router bit is suitable for edge profiling, trimming and slotting in laminate and comparable sheet materials when used in compatible routers.

Advantages

The carbide cutting head offers improved wear resistance on abrasive laminate surfaces compared with high-speed steel, extending service life. The 19 mm cutting length allows for deeper passes or handling thicker overlays, while the 100 mm total length provides additional reach for recessed or edge-mounted router setups. The straight geometry ensures a clean, consistent cut for trimming edges and creating straight slots.

Suitable for

• Edge profiling and trimming of laminated boards and panels
• Cutting straight slots and grooves in laminate and composite sheet materials
• Trimming laminate overhangs after gluing or installation
• Use in handheld or table-mounted routers with suitable collet and shank clearance

When it may not be suitable

This router bit is designed specifically for laminated and similar sheet materials; it may not perform optimally on solid hardwoods, dense tropical species or materials containing embedded metal without reduced life and potential chipping. For profiled or decorative edge mouldings that require specific radii or bearing-guided cutters, a dedicated profile bit is more appropriate.

Key specifications

• Cutting material: carbide (HW)
• Cutting length: 19 mm
• Total length: 100 mm
• Geometry: straight cutting edge
• Supply quantity: 1 piece

How to use

Install the router bit in a router whose collet and maximum shank length accommodate the 100 mm total length and the shank diameter used by the router. Securely tighten the collet according to the router manufacturer's torque recommendations. Make test cuts in scrap material to set depth and feed rate; use moderate feed speeds and multiple light passes when working with laminate to reduce chipping. Maintain consistent router movement and support the workpiece to prevent tear-out. After use, clean the carbide edges and store the bit in protective packaging to avoid damage.

What to consider before purchase

• Confirm router collet compatibility and shank diameter clearance for the 100 mm total length.
• Ensure the bit geometry and cutting length (19 mm) match the intended depth of cut in your laminated material.
• Check that your router and router base provide adequate support for safe, controlled cutting with a long bit.

Usage recommendations

Use progressive depth passes, a sharp carbide edge, and proper dust extraction when routing laminate. For best results, clamp the workpiece firmly and run trial cuts on scrap to fine-tune feed rate and spindle speed appropriate for laminate materials.