Magnetic Bit Holder MODECO 1/4" Steel 150 mm MN-16-102

Magnetic Bit Holder MODECO 1/4" Steel 150 mm MN-16-102 is a 1/4" steel accessory engineered to hold screwdriver bits securely using magnetic retention. With a 150 mm working length, this bit holder extends reach to recessed or hard-to-access fasteners and provides stable engagement between driver and bit. It is compatible with hand drivers and power tools that accept 1/4" hex bits and is intended for general fastening tasks where improved bit control and reach are required.

Advantages

The steel construction offers durability and resistance to bending under typical fastening loads. Magnetic retention keeps bits firmly in place during rotation, reducing slippage and lost bits. The 150 mm length increases reach into recessed screw heads and tight spaces while preserving tactile feedback when used with manual drivers. Compatibility with standard 1/4" hex bits makes it a versatile accessory for a wide range of screwdriving applications.

Suitable for

• Reaching recessed or deep-set screws in furniture assembly
• Fastening tasks in tight or hard-to-reach spaces
• Use with cordless drills and electric screwdrivers accepting 1/4" hex bits
• General maintenance, repair and installation work requiring bit stability

Key specifications

• Bit shank size: 1/4" hex
• Material: steel
• Overall/working length: 150 mm
• Retention: magnetic

How to use

Insert a compatible 1/4" hex screwdriver bit into the holder until it seats against the magnetic retention. Fit the holder into the chuck or bit socket of your hand driver or power tool and secure according to the tool manufacturer's instructions. Use steady pressure to keep the bit engaged with the fastener head; the magnetic retention helps maintain contact during rotation. Remove bits by pulling them straight out from the holder when the tool is not running.

Usage recommendations

For best results, use appropriately rated bits for the screw type and size, avoid excessive side-loading that could bend the holder, and disconnect power before changing bits. Inspect the holder periodically for wear or damage and replace if the magnetic retention or shank shows signs of failure.