Cutting Pliers MODECO MN-20-117 Americana 180 mm – side cutters, insulated handles

MODECO MN-20-117 Americana 180 mm side cutting pliers are designed for precise lateral cutting of wires and small metal components. With a total length of 180 mm and hardened cutting edges, these side cutters deliver accurate cuts in electrical, automotive and general repair tasks. The tool is fitted with ergonomic insulated handles that improve grip and provide an additional layer of safety during repetitive use.

Advantages

Hardened cutting edges ensure long-lasting sharpness and consistent cutting performance for copper, aluminium and soft steel wires. The compact 180 mm design gives good access in tight spaces while maintaining sufficient leverage for controlled cutting. Insulated ergonomic handles reduce hand fatigue and improve handling during frequent operations. Robust construction and precise jaw alignment support reliable lateral cutting without damaging adjacent components.

Suitable for

• Cutting electrical wires and cables
• Automotive wiring and small component trimming
• General repair and maintenance tasks in workshops
• Hobby and DIY projects requiring precise lateral cuts

Key specifications

• Total length: 180 mm
• Tool type: side cutting pliers / side cutters
• Cutting edges: hardened steel
• Handles: insulated, ergonomic design for improved grip
• Primary use: cutting wires and small metal components

How to use

Position the wire or component between the hardened cutting edges near the pivot point for the cleanest cut. Apply steady pressure to the handles until the cutting edges pass through the material. For thicker conductors, use short, controlled bites rather than a single excessive forceful action to avoid stressing the tool. After use, wipe the pliers clean and store them in a dry place to protect the cutting edges and insulation.

Usage recommendations

Use the pliers only within their intended range: cutting wires, small pins and soft metal components. Avoid cutting hardened steel bolts, nails or materials that exceed the tool’s rated capacity. Regularly inspect cutting edges for wear and handles for insulation damage; replace the tool if any damage is found to maintain safe operation.