Clamping Bar / Carpenter's Clamp MODECO STRONG MN-37-266 120×800 mm

MODECO STRONG MN-37-266 120×800 mm clamping bar is a carpenter's clamp designed to hold, align and press workpieces during woodworking and assembly. The tool provides continuous, rigid clamping force along its 800 mm length and supports glue-ups, edge jointing and general carpentry operations that require stable pressure and straight alignment. The simple bar design ensures even distribution of force and straightforward operation on a variety of materials.

Advantages

The clamping bar features a long, rigid rail that gives uniform pressure across the clamped area and helps prevent warping during adhesive curing. Its flat bar profile and adjustable sliding jaw allow rapid positioning and reliable holding of workpieces. The robust construction ensures resistance to bending under typical carpentry loads and offers a low-maintenance solution for repetitive clamping tasks.

Suitable for

• Panel glue-ups and edge gluing
• Aligning and holding parts during assembly
• Cabinet, furniture and countertop fabrication
• General woodworking and shop fixtures requiring long, straight clamping

Key specifications

• Clamping capacity: 120 × 800 mm
• Bar length: 800 mm working span
• Clamping jaw type: fixed and adjustable sliding jaw
• Profile: flat long bar for distributed pressure
• Intended use: carpentry and woodworking clamping

How to use

Position the fixed jaw against one end of the workpiece, slide the adjustable jaw along the bar until it makes contact with the opposite face, then apply clamping pressure by tightening the mechanism according to the required holding force. Ensure the workpieces are aligned before applying full pressure. For glue-ups, tighten evenly along the length and check that surfaces remain flush and square during adhesive curing.

Usage recommendations

Use protective pads between the clamp jaws and finished surfaces to avoid marking. For best results in glue-ups, apply moderate, even pressure rather than maximum torque; inspect alignment periodically while adhesive cures. Store the clamping bar in a dry place to prevent corrosion and check the rail for straightness before precision work.