Drill bit MODECO SDS+ 8 mm MN-61-131 for concrete

Modeco SDS+ 8 mm drill bit MN-61-131 is designed for drilling into concrete and masonry with SDS+ rotary hammers. The 8 mm carbide-tipped head and steel body provide accurate hole formation for anchors, dowels and fasteners. The shank fits SDS+ chucks to ensure stable retention during rotary hammer operation, offering consistent performance for both professional and DIY tasks that require reliable concrete penetration.

Advantages

The carbide tip is engineered for wear resistance and effective cutting of concrete and masonry materials, while the SDS+ shank design allows quick and secure tool changes. The 8 mm diameter balances speed and control for common anchor sizes and fixing applications. The bit’s construction reduces wobble and improves hole straightness, supporting precise installation of fasteners.

Suitable for

• Drilling holes in concrete for anchors and dowels
• Installing wall plugs and fasteners in masonry
• Professional construction and renovation tasks requiring reliable concrete drilling
• DIY projects involving concrete or brick where SDS+ rotary hammers are used

Key specifications

• Diameter: 8 mm
• Shank type: SDS+
• Tip material: Carbide
• Intended material: Concrete and masonry
• Typical use: Rotary hammer drilling for anchors, dowels and fasteners

How to use

Attach the drill bit to an SDS+ rotary hammer following the tool manufacturer’s instructions until it locks securely. Mark the drilling point and start at low speed to establish the hole, then apply steady pressure and use the hammering function for concrete or masonry. Withdraw the bit periodically to clear dust and debris and maintain drilling efficiency. Use appropriate personal protective equipment such as eye protection, hearing protection and a dust mask while drilling.

Usage recommendations

For best results, match the 8 mm drill bit to anchors and plugs specified for that diameter, select the correct drilling depth with a depth stop where available, and allow the carbide tip to do the cutting without excessive lateral force. Replace the bit if wear or tip damage occurs to maintain hole quality and drilling safety.