Drill bit MODECO SDS+ 14 mm MN-61-168 for concrete

MODECO SDS+ 14 mm concrete drill bit (14 mm Ø) is designed for use with SDS+ rotary hammers to drill precise holes in concrete, masonry and natural stone. The carbide-tipped head provides wear resistance and efficient material removal while the flute geometry evacuates dust and debris to maintain drilling stability. This bit is intended for creating anchor and fastening holes, as well as openings for electrical and plumbing penetrations.

Advantages

The carbide tip ensures longer life and sustained cutting performance in abrasive materials. Optimised flute design improves dust evacuation and reduces clogging, which helps maintain drilling speed and straightness. The SDS+ shank connection provides secure bit retention and quick installation or removal in compatible rotary hammers. The 14 mm diameter offers a balance between hole strength and material removal rate for standard anchor and fixing sizes.

Suitable for

• Drilling anchor and fixing holes in concrete
• Preparing openings for electrical conduit and plumbing sleeves
• Drilling into masonry blocks and natural stone
• Work with SDS+ rotary hammers on construction and renovation sites

Key specifications

• Diameter: 14 mm
• Tip material: carbide
• Connection type: SDS+
• Intended materials: concrete, masonry, natural stone
• Typical use: rotary hammer drilling for anchors and penetrations

How to use

Install the MODECO SDS+ 14 mm bit into an SDS+ compatible rotary hammer until it locks into place. Select hammer or hammer-drill mode depending on your tool and the material hardness. Position the bit perpendicular to the work surface, apply steady pressure and allow the tool to deliver impact action; avoid forcing the bit to prevent overheating or premature wear. Withdraw the bit periodically to clear debris and check hole depth for accurate anchor placement. Use appropriate personal protective equipment such as eye and hearing protection and a dust mask when drilling.

Usage recommendations

For best performance, match drill speed and hammer setting to the material: lower impact settings for softer masonry and higher settings for dense concrete. Replace the bit if the carbide tip shows significant wear or the bit no longer drills straight. Ensure compatibility with your rotary hammer's SDS+ chuck before use.