Drill bit MODECO SDS+ 16 mm MN-61-175 for concrete

MODECO SDS+ 16 mm drill bit MN-61-175 is designed for rotary-percussion drilling in concrete and other hard mineral materials. The 16 mm diameter and SDS+ shank make it compatible with SDS+ hammer drills, enabling efficient creation of anchor holes and through-holes for installation work. Intended for use on concrete and reinforced concrete, this drill bit is suited to professional and DIY masonry tasks where a durable cutting tool and secure shank retention are required.

Advantages

The SDS+ shank provides quick, secure fitting in compatible chucks and reduces slippage during percussion drilling. The 16 mm cutting diameter balances hole size and drilling speed for common anchor and fastening applications. The bit is built for repeated use in hard mineral substrates, maintaining cutting efficiency under rotary-percussion load. Its geometry supports effective dust removal and reduces binding when advancing through concrete.

Suitable for

• Drilling anchor and fixing holes in concrete and reinforced concrete
• Installation of electrical boxes, fixtures and pipe supports
• General masonry work and renovation that requires SDS+ tools
• Preparing holes for dowels, screws and chemical anchors

Key specifications

• Drill diameter: 16 mm
• Shank type: SDS+ compatible
• Intended materials: concrete, reinforced concrete, hard mineral materials
• Operation mode: rotary-percussion drilling

How to use

Install the drill bit into an SDS+ hammer drill according to the tool manufacturer's instructions until it locks securely. Mark the drilling point and start drilling at low speed to create a guide, then increase to the recommended percussion drilling speed for the material. Apply steady axial pressure without forcing the bit; allow the hammer action to perform the cutting. Periodically withdraw the bit to clear dust and debris from the hole and to prevent overheating. For deeper holes, extract the bit more frequently to remove accumulated material.

Usage recommendations

Use appropriate personal protective equipment such as safety glasses, hearing protection and dust mask when drilling concrete. Select a hammer drill with suitable power and percussion rate for a 16 mm SDS+ bit; when drilling reinforced concrete, use moderate speed and steady pressure to avoid rapid wear. For anchoring applications, verify hole depth and clean the hole thoroughly before inserting anchors or adhesives.