Adapter MODECO SDS-Plus to 1/2" (male) MN-61-395

Adapter MODECO SDS-Plus to 1/2" (male) MN-61-395 converts an SDS-Plus chuck on a rotary hammer or drill into a holder that accepts standard 1/2" male-shank bits and accessories. Designed to expand the compatibility of SDS-Plus machines, the adapter allows the use of common drill bits, core bits, and other 1/2" shank tools for drilling and light chiselling in construction, renovation and installation work.

Advantages

The adapter provides a secure mechanical connection between an SDS-Plus tool and 1/2" male shank accessories without requiring permanent modifications to the machine. Its compact design preserves tool balance and maneuverability while allowing quick interchange of standard accessories. Manufactured to MODECO quality standards, the adapter is suitable for workshop and site use, offering a practical solution to extend the range of tools usable with SDS-Plus hammers and drills.

Suitable for

• Drilling concrete, masonry and stone with standard 1/2" shank bits
• Using core bits and hole saws that require a 1/2" drive
• Light chiselling tasks where SDS-Plus machine impact is not required or when using non-SDS chisels
• General renovation, installation and maintenance work requiring varied accessory compatibility

Key specifications

• Compatibility: fits SDS-Plus tool holder to accept 1/2" (12.7 mm) male shank accessories
• Connection type: SDS-Plus female interface to 1/2" male shank output
• Material and finish: metal construction suitable for impact and rotational loads
• Size: compact adapter profile for limited interference with chuck clearance
• Use case: for drilling and light chiselling with standard 1/2" shank tools

How to use

Insert the adapter into the SDS-Plus chuck or tool holder following the machine manufacturer's recommended insertion method until it locks. Insert the 1/2" male shank accessory into the adapter and secure it according to the accessory's fastening requirements. Before starting, verify that the adapter and accessory are fully seated and that the machine is set to the appropriate mode (rotary or rotary with impact disabled when required). Use steady, controlled feed and avoid side loads that could stress the adapter connection.

Usage recommendations

For safety and optimal performance, use the adapter only with accessories and machines within the intended operating range. Do not use the adapter for heavy-duty demolition where a dedicated SDS-Plus bit is required. Regularly inspect the adapter for wear or damage and replace it if deformation or excessive wear is visible. Always follow the rotary hammer manufacturer's safety instructions, wear appropriate personal protective equipment, and match speed and impact settings to the accessory and material.