Drill Bit MODECO SDS+ 10 mm MN-61-917

MODECO SDS+ 10 mm drill bit MN-61-917 is designed for use with SDS+ rotary hammers and percussive drilling. With a 10 mm cutting diameter and an SDS+ shank, this drill bit is intended for drilling into concrete, masonry and natural stone where an SDS+ connection is required. The bit geometry and carbide tip are optimised for impact drilling, providing repeatable hole accuracy for construction, repair and installation tasks.

Advantages

The SDS+ shank ensures secure fitment and quick bit changes in compatible rotary hammers. A hard-wearing carbide tip improves durability and maintains cutting performance when working with aggregate and reinforced concrete. The 10 mm diameter offers a balance between speed and control for common anchor and dowel holes, while the flute design helps clear dust and chips during percussive drilling.

Suitable for

• Drilling anchors, plugs and dowels in concrete and masonry
• Installation of electrical boxes and conduit in block or brick walls
• Repair and renovation tasks requiring percussive drilling with an SDS+ rotary hammer
• Preparing holes in natural stone and hard mortar

Key specifications

• Cutting diameter: 10 mm
• Shank type: SDS+
• Intended materials: concrete, masonry, natural stone
• Tip material: carbide cutting tip
• Application type: percussive (hammer) drilling

How to use

Insert the SDS+ shank into the rotary hammer chuck until it locks according to the tool manufacturer's instructions. Select an appropriate drilling speed and engage the hammer function when drilling into concrete or masonry. Apply steady axial pressure while allowing the tool to perform the percussive action; avoid excessive side load to prolong tip life. Withdraw the bit periodically to clear dust and debris from the hole for improved drilling efficiency and hole quality.

Usage recommendations

Use appropriate personal protective equipment including eye and hearing protection and a dust mask when drilling masonry and concrete. For reinforced concrete, pilot drilling and progressive hole enlargement with suitable bit sizes can reduce stress on the carbide tip. Store the drill bit in a dry place and avoid striking the tip on hard surfaces when not in use.