Drill Bit MODECO SDS+ 12 mm MN-61-922 — carbide tip, SDS+ shank

MODECO SDS+ 12 mm drill bit MN-61-922 is designed for use with rotary hammers that accept SDS+ shanks. The 12 mm diameter and carbide tip make this bit suitable for drilling holes in concrete, masonry and natural stone where percussion action is required. The SDS+ shank ensures secure retention and fast bit changes during construction and renovation tasks that demand repetitive, reliable drilling performance.

Advantages

The carbide tip provides enhanced wear resistance and maintains cutting performance over extended use, resulting in consistent hole quality. The SDS+ shank offers stable engagement with the rotary hammer chuck, reducing slippage and simplifying replacement. A 12 mm diameter balances hole size and material removal rate for typical anchor, dowel and service-through hole applications in building materials.

Suitable for

• Drilling holes for anchors and dowels in concrete and masonry
• Creating passages for pipes and cables in walls and floors
• General demolition and renovation where percussion drilling is required
• Installation of fixtures, brackets and fastening points in stone or brick

Key specifications

• Diameter: 12 mm
• Tip material: carbide
• Shank type: SDS+
• Intended use: percussion drilling in concrete, masonry and natural stone
• Typical tool compatibility: rotary hammers with SDS+ chuck

How to use

Fit the drill bit into an SDS+ rotary hammer according to the tool manufacturer's instructions, ensuring the shank locks securely. Select the hammer-percussion mode for drilling into concrete or masonry. Start drilling at low speed to establish the position, then apply steady pressure and allow the tool to do the work; avoid excessive lateral force. Withdraw the bit periodically to clear dust from the hole and improve cutting efficiency, and use appropriate personal protective equipment such as eye and hearing protection.

Usage recommendations

For prolonged service life, match drilling speed and applied pressure to the material hardness, clear debris frequently, and avoid using the bit for non-recommended materials such as metals. When drilling deep holes, remove the bit occasionally to evacuate dust and reduce overheating of the carbide tip.