Continuous sanding belts MODECO MN-68-466/5 with abrasive grit 60, size 457 x 75 mm, sold in a pack of 5. These belts are intended for use with compatible belt sanders to perform material removal, surface leveling and preparation on wood, metal and composite surfaces. The medium-coarse grit provides efficient stock removal while maintaining control for shaping, smoothing edges and removing old coatings in workshop and renovation tasks.
Advantages
The abrasive grain size 60 delivers a balance between aggressive cutting and surface finish, allowing faster removal of material compared with fine grits while avoiding the deepest scratches of very coarse abrasives. The continuous belt construction ensures consistent contact with the workpiece and stable performance during extended use. Supplied as a pack of five, the belts reduce downtime by providing replacements when wear appears, and their standard 457 x 75 mm dimensions fit a wide range of common belt sander models.
Suitable for
- Shaping and smoothing wooden boards and panels
- Removing paint, varnish and old coatings from surfaces
- Edge sanding and deburring of metal components
- Preparing composite materials for finishing or bonding
- Workshop and renovation tasks requiring medium-coarse abrasion
Key specifications
- Abrasive grit: 60 (medium-coarse)
- Dimensions: 457 x 75 mm
- Quantity: pack of 5 continuous belts
- Suitable for belt sanders compatible with 457 x 75 mm belts
- Intended materials: wood, metal, composite surfaces
How to use
Before fitting a new belt, disconnect the power and ensure the sander is switched off. Fit the continuous belt onto the sander according to the machine manufacturer's instructions, align tracking and tension as required, and perform a brief test run to check tracking. Start sanding with moderate pressure and move the sander steadily across the surface to avoid gouging. Replace belts when the abrasive is worn, glazing occurs, or when cutting efficiency drops.
Usage recommendations
For best results, use grit 60 belts for initial shaping and coating removal, then progress to finer grits for smoothing and finishing. Work in the direction appropriate for the material (with the grain on wood), maintain consistent feed speed, and avoid excessive pressure that can cause premature belt wear or damage to the workpiece.
