Aluminum spirit level MODECO 2 vials 100 cm MN-70-010

Aluminum spirit level MODECO 2 vials 100 cm MN-70-010 is a 100 cm lightweight leveling tool with two acrylic vials for horizontal and vertical alignment. The rigid aluminum profile provides stable support and reduces flexing during measurement, while the clearly visible bubble vials allow quick verification of level and plumb on a range of surfaces. The spirit level is intended for general carpentry, construction and DIY tasks where straightforward, repeatable alignment is required.

Advantages

The aluminum construction combines light weight with structural rigidity for accurate readings without excessive operator effort. Two precisely positioned acrylic vials give clear visual feedback for both horizontal (level) and vertical (plumb) alignment. The 100 cm length strikes a balance between reach and portability for measuring longer spans and checking straightness, and the corrosion-resistant surface maintains performance in typical workshop and site conditions.

Suitable for

• Checking horizontal surfaces, shelves and worktops
• Verifying vertical alignment of posts, door frames and cabinets
• Checking straightness and continuity of walls and beams
• General carpentry, installation and renovation tasks

Key specifications

• Length: 100 cm
• Profile material: aluminum
• Number of vials: 2 (horizontal and vertical)
• Vial material: acrylic
• Application: level and plumb measurement for carpentry and construction

How to use

Place the aluminum spirit level on the surface to be checked, ensuring full contact along the profile. For horizontal checks, position the level across the surface and observe the central bubble within the horizontal vial; adjust the surface until the bubble centers between the marked lines. For vertical checks, align the level against the upright surface and read the vertical vial in the same way. Re-check after any adjustment to confirm consistent alignment along the measured span.

Usage recommendations

To maintain accuracy, store the level in a dry place and avoid drops or heavy impacts. Clean the vials and profile before measurement to remove dust or debris that could affect contact. For higher-precision tasks, verify vial calibration occasionally by placing the level on a known flat surface and rotating it 180° to confirm consistent bubble position; if misaligned, service or replace the tool.