Mixing Paddle for Gypsum MODECO MN-79-077 100×500 mm

The MODECO Mixing Paddle for Gypsum MN-79-077, sized 100×500 mm, is a tool designed for use with a power drill to mix gypsum-based compounds, plasters and mortars. Its geometry and length are intended to promote even blending while minimising splashing and air entrapment. The paddle is suitable for on-site and workshop use where consistent, lump-free mixtures are required for finishing and repair tasks.

Advantages

The paddle’s blade profile provides efficient circulation of material to reduce clumping and speed up mixing time. A robust shaft and welded construction ensure stable performance when used with standard drills at recommended speeds. The 100 mm diameter and 500 mm length balance mixing capacity with manoeuvrability, allowing work in both small buckets and larger mixing containers without excessive turbulence.

Suitable for

• Mixing gypsum plaster and gypsum-based finishing compounds
• Preparing cement-sand mortars and repair mixes in small batches
• DIY renovation tasks and professional site work
• Blending additives or pigments into base compounds

Key specifications

• Blade diameter: 100 mm
• Overall length: 500 mm
• Compatibility: fits most drill chucks for use as a mixing accessory
• Material: steel construction with welded blade to shaft for rigidity
• Design: angled blade geometry to reduce splashing and improve circulation

How to use

Fit the paddle securely into the drill chuck and tighten according to the drill manufacturer’s instructions. Place the paddle into the container before starting the drill to avoid material splatter. Begin mixing at low speed to wet out the dry powder, then increase speed gradually until the compound reaches a uniform, lump-free consistency. Withdraw the paddle slowly while the drill is running at low speed to avoid drips and material loss.

Usage recommendations

Use within the drill’s recommended torque and speed limits; excessive speed can cause splashing and may overload the drill. Clean the paddle after each use to prevent hardened residue—soak and remove material before storing. For large volumes or industrial applications, consider using a purpose-built mixer with a larger capacity paddle.