MODECO paddle drill bit set MN61756 includes seven spade bits in sizes 12, 16, 18, 20, 22, 24 and 26 mm, designed for cutting large-diameter holes in wood and similar materials. Each bit features a flat blade with a central point for precise positioning and saw-like cutting edges to remove material efficiently. The set is suitable for use with handheld drills and drill presses, intended for carpentry, electrical, plumbing and general construction tasks where quick, straight holes through soft to medium-density timber are required.
Advantages
The paddle bits provide fast chip removal due to their wide flat blade and large flutes, reducing clogging and allowing quicker drilling compared with twist bits of similar diameter. The central point ensures accurate centring on the workpiece, while the sharpened cutting edges deliver clean entry and exit holes with minimal tear-out when used at appropriate speeds. The included size range covers common large-hole requirements without needing multiple tool changes.
Suitable for
- Drilling holes for cable and pipe routing in wooden studs and panels
- Creating passage holes for door hardware and fittings
- Rapid rough drilling in carpentry and framing work
- Use in workshop drill presses for controlled-depth holes
- General-purpose large-diameter holes in soft and medium-density wood
Key specifications
- Bit type: paddle (spade) drill bits with central point
- Material: high-carbon steel or similarly hardened tool steel typical for spade bits
- Working diameters: 12 mm, 16 mm, 18 mm, 20 mm, 22 mm, 24 mm, 26 mm
- Shaft type: standard round shank compatible with common drill chucks
- Intended materials: soft and medium-density wood, plywood, OSB and similar wood-based panels
- Use cases: handheld drills and drill press operation
How to use
Mark the drilling location and secure the workpiece to prevent movement. Select the required paddle bit size and insert it firmly into the drill chuck, tightening the chuck securely. Start drilling at low speed to allow the central point to engage and to maintain control, then increase speed moderately for faster cutting while avoiding excessive heat buildup. Apply steady pressure; allow the bit to cut without forcing. For through-holes, back the bit out periodically to clear chips and improve cutting performance. When drilling from a finished surface, consider backing the workpiece with scrap wood or finish-side out to reduce tear-out.
Usage recommendations
Use appropriate personal protective equipment including eye protection and hearing protection. For larger diameters, use moderate drill speed and avoid overheating; if cutting hard or resinous woods, withdraw the bit occasionally to clear chips. Secure thin workpieces and consider a support block to preserve edge quality. Store bits in a dry place to prevent corrosion.
