Montolit milling cutter FSB 6 MONDRILLO BLACK diameter 6 mm for dry/wet use

Montolit milling cutter FSB 6 MONDRILLO BLACK diameter 6 mm for dry/wet use is a compact router bit designed for precision work on tile, ceramic and similar hard materials. With a 6 mm shank it fits hand-held routers and CNC machines that accept this shaft size. The cutter is intended for profiling, trimming, and edge finishing where controlled material removal and a smooth edge are required. It is engineered for both dry and wet milling conditions to suit different workshop setups and jobsite requirements.

Advantages

The Montolit FSB 6 MONDRILLO BLACK combines a small-diameter 6 mm shank with a cutting geometry optimised for hard, brittle materials to reduce chipping and produce consistent edge quality. Its construction supports both dry and wet use, allowing flexibility between clean-shop wet cutting and dry on-site operations. The compact profile ensures compatibility with a wide range of routers and CNC spindles that accept a 6 mm shaft, providing stable performance during precision trimming and profiling tasks.

Suitable for

• Precision profiling and edging of ceramic and porcelain tiles
• Trimming and finishing edges after cutting or installation
• Small-scale routing tasks in hand-held routers with 6 mm shank collets
• CNC machining of tile components where a 6 mm tool holder is used
• Both dry on-site operations and wet shop milling

Key specifications

• Shank diameter: 6 mm
• Intended materials: tile, ceramic, porcelain and similar hard, brittle materials
• Operation: suitable for dry and wet milling
• Typical applications: profiling, trimming, edge finishing
• Compatibility: hand-held routers and CNC machines accepting 6 mm shanks

How to use

Secure the milling cutter in a router or CNC spindle that accepts a 6 mm shank and ensure the collet is tightened to the manufacturer's recommended torque. Select appropriate rotation speed and feed rate for tile or ceramic materials, using slower feeds and higher spindle speeds typical for small-diameter diamond or carbide tooling. For wet milling, set up a controlled coolant or water flow to remove debris and reduce heat; for dry milling, use proper dust extraction and take lighter passes to minimise chipping. Work in steady passes, avoid lateral shock, and inspect the edge after each pass to confirm desired finish quality.

Usage recommendations

Use personal protective equipment including eye protection and dust mask for dry work. When milling wet, ensure electrical safety measures and proper water management. Test cut on a scrap piece to fine-tune speed and feed settings for the specific tile type before working on the final piece.