Montolit solid crown carbide drill bit 6 mm MU6 for masonry and tile

Montolit solid crown carbide drill bit 6 mm MU6 is a specialist drill designed for drilling clean, precise holes in masonry and ceramic tile. The solid full-crown carbide head delivers wear-resistant cutting performance for through-holes and anchor points. This 6 mm diameter bit is intended for use with standard drills and rotary tools on hard substrates where accurate hole diameter and neat edges are required.

Advantages

The solid crown carbide tip offers high durability and consistent cutting quality, reducing chipping on ceramic glazes and minimizing bit wear on masonry. The full-crown geometry supports stable rotation and even material removal, which helps keep hole walls smooth and accurate. The bit’s 6 mm diameter makes it suitable for common fixings and anchors, and the carbide construction maintains cutting ability over repeated use.

Suitable for

• Drilling through ceramic wall and floor tiles
• Making anchoring and fixing holes in brick and concrete
• Creating precise 6 mm passages for dowels and screws in hard substrates

Key specifications

• Cutting material: solid carbide crown
• Diameter: 6 mm
• Head type: full-crown (solid) cutting head for through-holes
• Intended substrates: masonry and ceramic tile
• Compatible tools: standard drills and rotary tools

How to use

Secure the workpiece and mark the drilling point accurately. Fit the 6 mm drill bit into the drill chuck and tighten firmly. Begin drilling at low speed to establish the hole position, then increase speed as appropriate for the substrate while maintaining steady, even pressure. For ceramic tiles use a backing support or tape to reduce surface chipping; for masonry apply intermittent drilling to avoid overheating. Withdraw the bit regularly to clear debris and allow the tip to cool.

Usage recommendations

Use appropriate personal protective equipment, such as safety glasses and gloves. Match drilling speed to the material—lower speeds for ceramic tiles and moderate speeds for masonry. If drilling multiple holes in hard substrates, allow occasional cooling pauses to prolong bit life. For best results on glazed tiles, start with light pressure and avoid hammer function on the drill unless specified for masonry use.