Spray paint can Motip Autoacryl 52200 — 400 ml, acrylic automotive spray

Motip Autoacryl 52200 is a 400 ml acrylic aerosol paint formulated for automotive applications. This fast-drying acrylic spray delivers an even coating suitable for small repairs, spot painting and touch-ups on vehicle bodies and plastic or metal parts. Packaged in a pressurised spray can with a spray nozzle, the product is designed for direct surface application where ease of use and quick results are required.

Advantages

The acrylic formulation offers rapid drying and good surface adhesion on prepared metal and many automotive plastics. The aerosol format enables precise application for small areas and reduces preparation time compared with conventional paint methods. The product provides a smooth finish with low drip tendency when applied in thin, even layers and is compatible with standard surface preparation and clearcoat systems used in automotive repair.

Suitable for

• Small paint repairs and spot touch-ups on vehicle bodies
• Retouching bumpers, trims and exterior plastic parts
• Quick corrective painting after minor scratches or stone chips
• Workshop or DIY maintenance where fast-drying spray paint is needed

Key specifications

• Volume: 400 ml aerosol can
• Base: acrylic
• Drying behaviour: fast-drying
• Application: spray / aerosol for spot and small-area use
• Substrates: prepared metal and many automotive plastics

How to use

Ensure surfaces are clean, dry and free of rust, grease or loose paint before application. Shake the can vigorously for at least two minutes to homogenise the acrylic paint. Spray test on a scrap panel to check colour and spray pattern. Hold the can approximately 20–30 cm from the surface and apply several thin, even coats with short bursts rather than a single heavy pass. Allow appropriate flash-off time between coats until the desired coverage is achieved. After application and full drying, sand lightly if necessary and finish with a suitable clearcoat for increased gloss and protection.

Usage recommendations

Use in a well-ventilated area and follow personal protective equipment guidance: gloves, eye protection and a suitable respiratory mask when spraying. Store the aerosol in a cool, dry place away from direct heat and open flames. For best results on plastics, test adhesion in an inconspicuous area and use a recommended plastic adhesion promoter if needed.