MPL Power MW Power 15W 12V/1.25A round LED power supply IP67

MPL Power MW Power 15W 12V/1.25A round LED power supply IP67 is a compact, sealed constant-voltage driver designed to deliver 12V DC at up to 1.25A. Its 15W output and IP67 ingress protection make it suitable for outdoor, damp or washdown environments where a weatherproof power source is required. The round enclosure supports discreet installation in confined spaces or behind luminaires, and it is intended for LED strips, modules and other low-voltage LED luminaires that require a stable 12V supply.

Advantages

The driver provides a stable 12V DC output with a rated 1.25A current and 15W power capacity while maintaining full enclosure protection against dust and temporary immersion (IP67). Its compact round form factor simplifies mounting in tight or concealed locations and reduces the need for additional enclosures. Designed specifically for LED applications, the unit is built to maintain consistent output suitable for constant-voltage LED systems in exposed or damp conditions.

Suitable for

• Outdoor LED strip lighting installations with 12V constant-voltage requirements
• LED modules and low-voltage luminaires in patios, facades or signage
• Damp or wet-area applications where IP67 protection is needed
• Retrofit projects requiring a compact sealed driver to fit behind fixtures

When it may not be suitable

This power supply is not intended for applications that require higher voltage or higher current than 12V/1.25A (15W). It is a constant-voltage driver and therefore not suitable for LED fixtures that require a constant-current source. For installations with long cable runs or high inrush current requirements, voltage drop and thermal considerations should be evaluated to ensure reliable performance.

Key specifications

• Output voltage: 12V DC
• Maximum output current: 1.25A
• Maximum output power: 15W
• Ingress protection: IP67 (dust tight and protected against immersion)
• Form factor: round, compact sealed enclosure suitable for concealed mounting
• Intended use: constant-voltage LED driver for outdoor and damp locations

How to use

Install the MW Power 15W 12V/1.25A round LED power supply according to local electrical codes and manufacturer mounting instructions. Connect the AC supply to the input terminals or leads and verify correct mains wiring and grounding before energizing. Connect the 12V DC output to the LED load ensuring the total connected power does not exceed 15W and polarity is observed. Place the unit in a location compatible with IP67 protection—sealed from direct prolonged water jets if required—and allow adequate ventilation around the installation to prevent excessive heat buildup.

What to consider before purchase

• Confirm total LED load does not exceed 15W and that the load is constant-voltage (12V) compatible
• Verify that IP67 rating meets environmental exposure expectations for the installation site
• Assess mounting space and cable entry options for the round enclosure in your installation area
• Ensure compatible wiring, connectors and overcurrent protection are specified per local regulations

Usage recommendations

Use the power supply within its rated limits: keep the connected load below 15W, maintain correct polarity, and follow IP67 installation guidelines. For extended cable runs use appropriately sized conductors to reduce voltage drop; if a constant-current driver or higher power is required, select a different driver matched to the fixture specifications.