Staple strip for pneumatic stapler MPL Power BAND 20-1 — 20 x 1.0 mm, 10 m, pre-galvanized

The MPL Power BAND 20-1 staple strip is a replacement ammunition for pneumatic staplers, sized 20 x 1.0 mm and supplied on a 10 m coil with a pre-galvanized finish. It is produced to feed BAND 20-1 compatible stapling tools and provides consistent staple formation suitable for a range of fastening jobs in construction, carpentry and upholstery. The pre-galvanized surface enhances resistance to corrosion and helps maintain performance in typical indoor and semi-exposed conditions.

Advantages

Consistently formed staples on a continuous 10 m coil reduce reload frequency and ensure smooth feeding in pneumatic staplers that accept the BAND 20-1 format. The 1.0 mm wire diameter delivers reliable holding power in soft to medium-density materials while the pre-galvanized coating provides basic rust protection. The product is compatible with standard production tolerances for BAND 20-1 strips, supporting predictable driving depth and staple clinch for repeatable results.

Suitable for

• General fastening in interior construction and light carpentry
• Upholstery and furniture assembly where fine-gauge staples are required
• Securing felt, insulation, textiles and thin sheet materials
• Temporary fixtures and finishing tasks that require consistent staple placement

Key specifications

• Staple leg length: 20 mm
• Wire diameter: 1.0 mm
• Coating: pre-galvanized for corrosion resistance
• Packaging form: continuous coil strip, 10 m length
• Format: BAND 20-1 compatible stapler strip

How to use

Load the 10 m staple coil into a compatible pneumatic stapler designed for BAND 20-1 strips following the tool manufacturer's loading procedure and safety instructions. Set stapler pressure appropriate to the workpiece material and perform a few test drives on scrap material to confirm correct driving depth and clinch. Replace or adjust air pressure and tool depth if staples under- or over-penetrate the substrate.

Usage recommendations

Store the staple strip in a dry environment to preserve the pre-galvanized coating and prevent corrosion. Use appropriate personal protective equipment when operating pneumatic staplers, and choose air pressure and driving depth settings based on material density to ensure secure fastening without damaging the workpiece.