Socket Bit 1/4" 4 mm, NEO tools 08-442, 6-point

NEO tools 1/4" Socket Bit, 4 mm, 6-point is a compact drive accessory intended for use with 1/4" bit holders, ratchets and driver handles. The 4 mm 6-point profile provides a precise seat on matching hex fasteners, reducing slippage and wear during assembly, maintenance and repair tasks where small, hard-to-reach fasteners are encountered.

Advantages

The hardened 6-point profile ensures secure engagement with hex fasteners and helps distribute torque evenly across flats. Its 1/4" drive shank is compatible with a wide range of common bit holders and hand tools. The compact length and accurate machining support work in confined spaces and contribute to consistent torque transfer and reduced rounding of fastener heads.

Suitable for

• Assembly of small mechanical and electronic components
• Maintenance and repair of bicycles, appliances and machinery with small hex fasteners
• Work in tight or recessed areas where compact sockets are required
• Use with 1/4" drive ratchets, bit holders and manual drivers

Key specifications

• Drive size: 1/4" compatible shank
• Working size: 4 mm hex (6-point)
• Profile type: 6-point (hexagonal) for positive engagement
• Material treatment: hardened and precisely machined working surfaces
• Length: compact form factor suitable for confined spaces

How to use

Insert the 1/4" shank of the socket bit into a compatible bit holder, ratchet or driver handle until it locks or seats securely. Fit the 4 mm hex end over the fastener, ensuring full contact with the flats before applying torque. Apply steady, controlled turning force appropriate to the fastener and application. Inspect the mating surfaces before and after use to avoid damage to fastener heads and to maintain the bit's condition.

Usage recommendations

For best results, use the socket bit with tools rated for 1/4" drives and avoid excessive impact or side loading. Keep the bit clean and free of debris; store in a holder or organizer to prevent corrosion and mechanical damage. Replace the bit if significant wear or rounding of the working edges is observed.