Screwdriver bit NEO tools 09-586, Torx T27, 1/4" drive, 50 mm length

NEO tools 09-586 is a set of five Torx T27 screwdriver bits with a 1/4" hex drive and a length of 50 mm, supplied in a blister pack. Manufactured from S2 tool steel and cold-forged for professional use, these impact-rated bits are intended for use with bit holders, impact drivers and cordless drills that accept 1/4" hex bits. The design includes a tip-slip protection system and a torque absorption system that together enable a high tightening torque of up to 21.8 Nm while extending service life.

Advantages

The bits are made of high-quality S2 tool steel and are cold-forged to ensure consistent geometry and durability. A tip-slip protection feature reduces cam-out and improves contact with Torx fasteners. The torque absorption system minimizes wear during high-torque applications, resulting in longer life compared with non-absorbing tips. The 50 mm length provides a balance between reach and control for common assembly and maintenance tasks.

Suitable for

• Automotive repair and maintenance where Torx T27 fasteners are used
• Furniture assembly and carpentry requiring Torx drive bits
• General maintenance and repair with 1/4" hex bit holders, cordless drills or impact drivers
• Professional workshop use and repetitive fastening tasks

Key specifications

• Bit type: Torx T27
• Drive: 1/4" hex
• Length: 50 mm
• Material: S2 tool steel, cold-forged
• Set size: 5 bits
• Impact-rated design with tip-slip protection
• Maximum tightening torque: up to 21.8 Nm (application dependent)

How to use

Select a Torx T27 bit from the set and insert it into a compatible 1/4" hex bit holder, impact driver or cordless drill. Ensure the bit is fully seated and engaged by checking the tip-slip protection interface before applying torque. Start fastening at low speed to confirm alignment, then increase speed or torque as required. For impact driver use, follow the tool manufacturer's guidance for correct settings and safe operation.

Usage recommendations

For longest service life, use these bits with appropriate 1/4" impact-rated holders and avoid excessive lateral loads. Match the torque setting of your tool to the fastener and material to prevent over-torquing. Replace bits if tip deformation or excessive wear is visible to maintain secure engagement with Torx fasteners.