Ball Joint Puller 400 mm NEO tools 11-806 – 400mm reach, mechanical puller

NEO tools 11-806 is a 400 mm ball joint puller designed to remove ball joints, tie rod ends and similar press-fit steering and suspension components. The mechanical puller features a long reach to access joints in confined or recessed areas and applies steady mechanical force to separate pressed components while minimising the risk of damage to surrounding parts. The tool is suitable for professional workshops and DIY vehicle repair tasks where a reliable, non-hydraulic extraction method is required.

Advantages

The 400 mm reach provides access to deep or hard-to-reach joints without dismantling surrounding components. Its mechanical design offers controlled, gradual force application for safer extraction compared with improvised methods. The puller’s construction is intended for repeated use under workshop conditions, providing stability and predictable performance when removing ball joints and similar press-fit fittings.

Suitable for

• Removing ball joints in passenger cars and light commercial vehicles
• Extracting tie rod ends and steering linkage components
• Accessing recessed suspension joints in tight engine bays
• Workshop and DIY vehicle repair where non-hydraulic extraction is preferred

Key specifications

• Reach: approximately 400 mm for access to deep-mounted components
• Type: mechanical puller for press-fit joints
• Intended use: ball joints, tie rod ends and similar steering/suspension fittings
• Operation: manual force application via mechanical screw or equivalent mechanism
• Construction: workshop-grade materials suitable for repeated use

How to use

Position the puller so that its jaws or contact points engage securely with the component to be removed and the forcing element aligns with the receiving surface. Tighten the central screw or actuating mechanism gradually to apply controlled force until the ball joint or tie rod end disengages. Inspect surrounding parts before and after extraction to ensure no damage has occurred and remove any debris or corrosion that could impede reassembly.

Usage recommendations

Use appropriate personal protective equipment and ensure the vehicle is safely supported before applying the puller. Where possible, apply penetrating lubricant to corroded joints and proceed with steady, incremental force rather than sudden impacts. If a component does not release after careful mechanical extraction, seek additional workshop procedures to avoid causing damage.