Rotary Tool Grinding/Sanding Supply NEO Tools 08-977 Diameter 7.5 cm Weight 35 g

The NEO Tools rotary tool grinding/sanding attachment 08-977 is designed for use with rotary polishers that accept an M14 thread holder. With a 75 mm diameter contact surface and a lightweight construction of approximately 35 g, the attachment provides steady contact with work surfaces and is intended for polishing and sanding tasks using hook-and-loop pads with an 80 mm attachment area. The flexible material balances conformity and control, helping maintain consistent pressure and surface contact during precision work.

Advantages

This attachment is lightweight and easy to handle, reducing operator fatigue during extended use. Its flexible construction permits better surface conformity for more even sanding and polishing results. The hook-and-loop interface enables quick pad changes and compatibility with a series of NEO TOOLS polishing pads sized for an 80 mm attachment surface. The unit is suitable for rotary polishers up to a recommended maximum speed of 20,150 rpm.

Suitable for

• Polishing small panels and curved surfaces
• Light sanding and surface preparation
• Detailing work on automotive and marine surfaces
• Finishing and buffing on wood, metal, and composites

Key specifications

• Diameter: 75 mm (contact surface)
• Recommended maximum speed: 20,150 rpm
• Compatible holder: M14 threaded shank
• Attachment type: hook-and-loop pad interface
• Material: flexible pad carrier for improved surface conformity
• Intended pad attachment surface: 80 mm
• Approximate weight: 35 g

How to use

Fit the attachment onto a rotary polisher with an M14 thread holder and ensure it is securely tightened before operation. Attach a compatible 80 mm hook-and-loop polishing pad to the interface, aligning it centrally for balanced rotation. Start the polisher at a low speed to confirm balance and pad seating, then gradually increase speed while observing the recommended maximum of 20,150 rpm. Apply light, even pressure and move the tool steadily across the work surface to achieve uniform sanding or polishing results. After use, clean the hook-and-loop surfaces to maintain good adhesion for future pad changes.

Usage recommendations

Use pads from the compatible 80 x 25 mm NEO TOOLS series for best fit and performance. Avoid exceeding the recommended maximum speed of 20,150 rpm and check that the M14 thread connection is properly secured before each use. For delicate surfaces, operate at lower speeds and reduce contact pressure to prevent damage.