Mounting profile A2.0 with foot by Niczuk, 30×30×2 mm, 30 cm (0930303000)

The Niczuk mounting profile A2.0 with foot is a compact metal profile with a 30×30×2 mm cross-section and a length of 30 cm. Designed to serve as a support and attachment point, this profile is intended for structural and mounting applications where a rigid, small-footprint profile is needed. The profile’s right-angled cross-section and integrated foot allow it to be fixed to flat surfaces and used as a base for panels, frames, shelving brackets or equipment mounts.

Advantages

This mounting profile provides stable mechanical support and straightforward attachment thanks to its solid metal construction and uniform wall thickness. Its compact dimensions make it suitable for installations with limited space while still offering sufficient stiffness for light- to medium-duty loads. The integrated foot simplifies alignment and fastening to horizontal surfaces, reducing the need for additional brackets or adapters.

Suitable for

• Framing and edge support for panels and screens
• Shelving and light racking supports in workshops or retail displays
• Mounting small equipment, controls, or fixtures to vertical or horizontal surfaces
• Joinery and custom furniture components requiring rigid corner or edge reinforcement

When it may not be suitable

This profile is made for light- to medium-duty structural tasks; it is not intended for heavy structural loads or where high structural safety factors are required. For applications exposed to aggressive corrosion environments, finishes or corrosion-resistant materials should be considered instead of assuming long-term bare-metal performance.

Key specifications

• Cross-section: 30 × 30 mm (L × W)
• Wall thickness: 2 mm
• Length: 30 cm
• Configuration: angle profile with integrated foot for surface mounting
• Material: metal profile suitable for mechanical fastening and machining

How to use

Measure and mark the installation points on the mounting surface, align the profile so the foot sits flush, and clamp temporarily if needed. Drill clearance or pilot holes through the foot according to fastener type, then secure the profile using appropriate screws, bolts or anchors for the surface material. When joining multiple profiles, ensure ends are cut square and use mechanical fasteners or gussets to maintain alignment. Deburr cut edges and consider protective finish or sealant in exposed installations.

What to consider before purchase

• Required load capacity and whether a single 30 cm section provides sufficient support
• Compatibility of the profile cross-section and foot with your fasteners and mounting surface
• Environmental exposure and whether a corrosion-resistant finish or different material is needed
• Need for cutting, drilling or additional brackets to achieve the intended assembly

Usage recommendations

Use appropriate fasteners matched to the mounting surface material, check alignment with a level before final tightening, and apply surface protection if the profile will be exposed to moisture or chemicals. For higher loads or safety-critical mounts, consult structural guidance or select a profile with greater cross-section or thickness.