Coaxial RF cable N male to SMA female with H155 dielectric, 10 m, No name

Coaxial RF cable N male to SMA female with H155 dielectric, 10 m, No name is a flexible, fixed-length transmission line intended for connecting equipment with N-type and SMA interfaces. The 10-meter length offers extended reach for test benches, antenna extensions and provisional installations. The H155 dielectric balances flexibility and electrical performance for moderate-frequency RF applications while maintaining consistent impedance along the run.

Advantages

This cable provides reliable RF signal continuity between N male and SMA female connectors without the need for adapters, reducing connection points and potential signal loss. The H155 dielectric contributes to stable characteristic impedance and acceptable insertion loss across moderate frequency ranges. Its flexible outer construction simplifies routing in confined spaces and temporary setups.

Suitable for

• Connecting test instruments and RF devices with N and SMA interfaces
• Antenna extensions where a 10 m fixed-length cable is required
• Laboratory and prototyping environments for moderate-frequency measurements
• Temporary networking and field setups that require a flexible, longer cable

Key specifications

• Connector 1: N male
• Connector 2: SMA female
• Dielectric: H155
• Length: 10 m
• Impedance: 50 ohm nominal
• Construction: flexible coaxial cable suitable for indoor and protected outdoor use

How to use

Verify that both the N male and SMA female interfaces on connected equipment are clean and free of debris. Align the connectors carefully and hand-tighten N and SMA terminations as appropriate; avoid over-tightening to prevent damage to threads or center contacts. Route the cable to minimize sharp bends and ensure bend radius is greater than the cable's minimum specification to preserve electrical performance. For temporary setups, secure the cable to prevent strain on connector joints.

Usage recommendations

Use this cable for moderate-frequency RF signal transmission where a 10 m, 50 ohm link between N and SMA devices is required. Avoid exposing the cable to prolonged direct sunlight or immersion; if outdoor use is necessary, protect connections and keep runs elevated from standing water. Periodically inspect connectors for corrosion or mechanical wear and replace the cable if performance degrades.