Abrasive semi-flexible disc NORTON CP FLEX 127 mm P60 for sanding (1 pc)

Abrasive semi-flexible disc NORTON CP FLEX 127 mm P60 is a single-piece sanding disc with a 127 mm diameter and P60 grit, intended for moderate material removal and surface preparation. The disc combines semi-flexible backing with an open-coat abrasive structure to provide consistent sanding performance on a variety of surfaces. It is suitable for use with handheld sanders or backing pads where some conformability to contours is required while retaining sufficient rigidity for controlled stock removal.

Advantages

The semi-flexible construction balances flexibility and support, allowing the disc to follow gentle curves without folding while maintaining even pressure across the abrasive surface. P60 grit delivers medium-coarse cutting action that is effective for removing paint, smoothing rough wood, deburring metal and preparing composite surfaces for finishing. The single-disc supply is convenient for small jobs or when specific grit selection is needed, and the abrasive formulation is designed for consistent life and predictable performance under typical sanding conditions.

Suitable for

• Sanding and paint removal on flat and slightly curved surfaces
• Smoothing rough timber and shaping wood before finer sanding
• Deburring and blending metal edges and weld seams
• Preparation of composite panels and fiberglass prior to finishing

Key specifications

• Diameter: 127 mm
• Abrasion grade: P60 (medium-coarse)
• Construction: semi-flexible backing with abrasive coating
• Pack quantity: 1 piece
• Compatible with: handheld sanders and backing pads designed for 127 mm discs

How to use

Attach the disc securely to a compatible backing pad or sander according to the tool manufacturer's instructions. Start sanding at low speed to verify fit and to avoid aggressive material removal, then increase speed and pressure as appropriate for the task. Move the sander evenly across the surface in overlapping passes, keeping the disc flat where possible on flat areas and allowing slight flex where following contours. Replace the disc when abrasive cutting becomes noticeably reduced or if the backing is damaged.

Usage recommendations

For best results use the P60 disc for initial stock removal and paint stripping, then progress to finer grits for finishing. Avoid excessive heat buildup by using consistent motion and moderate pressure; when sanding metal or composites, monitor for clogging and replace or clean the disc if loading occurs.