Cutting/Grinding Wheel Norton Clipper 200x20x32 mm 38A46NVS, model 66253338096

Norton Clipper cutting/grinding wheel 200x20x32 mm (38A46NVS) is a circular abrasive disc designed for use with compatible bench and handheld machines. With a 200 mm diameter, 20 mm thickness and 32 mm bore, this wheel combines abrasive grit and bonding characteristics suitable for cutting and grinding a range of construction materials when matched to the correct machine speeds and material types.

Advantages

The 38A46NVS abrasive specification provides a balance between cutting speed and surface finish for many common construction tasks. Its defined thickness and bore size ensure stable mounting and reduced vibration on properly fitted machines, improving operator control. The wheel is manufactured to consistent dimensional tolerances to maintain predictable performance and compatibility with standard 32 mm arbors.

Suitable for

• Cutting masonry and concrete elements where an abrasive wheel is appropriate
• Grinding and bevelling edges on construction materials
• Use on compatible bench grinders and angle grinders with a 32 mm arbor

Key specifications

• Diameter: 200 mm
• Thickness: 20 mm
• Bore (arbor) size: 32 mm
• Abrasion type/grit designation: 38A46NVS
• Shape: circular cutting/grinding disc

How to use

Install the wheel on a compatible machine with a 32 mm arbor, ensuring the machine is switched off and disconnected from power before mounting. Secure the wheel with the correct flanges and tighten according to the machine manufacturer’s instructions without over-torquing. Check the wheel for visible damage before each use and perform a short run-up at no-load speed to verify balance. During operation, use appropriate feed rates and maintain steady pressure; do not force the wheel into the material. Follow safe operating speeds recommended for the wheel’s design and the machine.

Usage recommendations

Use appropriate personal protective equipment including eye and face protection, hearing protection, gloves, and respiratory protection as required for the material being worked. Match wheel selection to the material and machine speed, and replace the wheel if any cracks, chipping, or excessive vibration are observed.