Abrasive Cutting Disc Norton Clipper 250x25x32 mm A60K for Concrete and Stone

The Norton Clipper abrasive cutting disc 250x25x32 mm A60K is designed for cutting concrete, natural stone and similar masonry materials. The disc has a 25 mm bore and is supplied with a 32 mm adapter, allowing compatible fitment on a range of angle grinders and bench cutters used in construction and renovation. Its A60K grit grade balances cutting speed and life for controlled material removal on reinforced and non-reinforced masonry.

Advantages

The disc provides stable cutting performance with consistent edge wear thanks to its abrasive formulation. Compatibility with both 25 mm bore motors and a 32 mm adapter increases tool versatility on site. Its dimensions and grit grade make it suitable for demanding concrete and stone tasks while helping maintain predictable cutting lines and reduced chipping when used with appropriate technique and equipment.

Suitable for

• Cutting concrete slabs and blocks
• Trimming natural stone and paving
• Precision cuts in masonry for renovation and installation
• Use on angle grinders and stationary cutters with adapter

Key specifications

• Diameter: 250 mm
• Arbor/bore: 25 mm (with 32 mm adapter included)
• Abrasive grit grade: A60K
• Material suitability: concrete, natural stone, masonry
• Typical application: wet or dry cutting depending on tool capability and worksite requirements

How to use

Mount the disc on a compatible angle grinder or bench cutter following the machine manufacturer’s instructions and ensure the 25 mm bore or 32 mm adapter is properly secured. Inspect the disc for damage before use. Operate the tool at the recommended speed and apply steady, moderate pressure—avoid excessive force that can cause overheating or accelerated wear. For reinforced concrete or thicker sections, make incremental passes rather than forcing a deep single cut. Use appropriate cutting technique to maintain straight lines and minimize chipping.

Usage recommendations

Use appropriate personal protective equipment including safety glasses, hearing protection, gloves and respiratory protection against dust. Where possible, use dust extraction or wet cutting to reduce airborne particles. Follow the grinder or cutter manufacturer’s RPM limits and safety instructions, and replace the disc if cracks, excessive wobble or abnormal wear are observed.