Drill bit DeWALT DT70753-QZ — single piece, weight 960 g

DeWALT DT70753-QZ drill bit — single-piece accessory weighing 960 g. This replacement drill bit is designed for compatibility with DeWALT SDS Plus systems and intended as a spare or single-use bit for general drilling tasks. Supplied as one unit, it is suitable when a specific model bit is required for repair, maintenance or continuing an existing tool setup.

Advantages

The single-piece design provides straightforward installation and stable performance in compatible rotary hammer and SDS Plus chuck systems. At 960 g, the bit offers a substantial, durable feel that supports sustained drilling operations. As an original-design accessory, it simplifies matching the correct geometry and fit for DeWALT tools, reducing the need to adapt other bits.

Suitable for

• Replacement of a worn or lost drill bit in compatible SDS Plus systems
• Occasional or professional drilling in masonry, concrete, and similar substrates (when used with appropriate SDS Plus rotary hammers)
• Maintenance kits where a single, specific bit is required

Key specifications

• Form factor: single-piece drill bit
• Compatibility: designed for SDS Plus chucks and systems
• Weight: 960 g per unit
• Intended use: general drilling tasks in masonry and concrete when used with suitable equipment

How to use

Install the bit into an SDS Plus-compatible rotary hammer or drill following the tool manufacturer's instructions. Ensure the tool is switched off and unplugged or the battery removed before changing accessories. Insert the shank fully into the chuck until it locks, then test the fitting at low speed. Select the appropriate drilling mode and speed for the material, use steady pressure without forcing the bit, and withdraw periodically to clear debris and prevent overheating.

Usage recommendations

Use appropriate personal protective equipment, including safety glasses, hearing protection and dust mask. Match the drill bit to the correct hammer and material type, and monitor the bit for wear; replace the bit if cutting performance declines or if any damage is visible.