Hole Saw Set NORTON 70184608385 — 12 pcs for wood and composite materials

Hole Saw Set NORTON 70184608385 — 12 pcs for wood and composite materials is a twelve-piece kit designed for cutting clean circular openings in wood and non-metallic composite materials. The set includes a range of diameters suited to interior carpentry work, door lock and handle installation, and routing for ducts or cables. Compatible with standard drill chucks and arbors, the saws are intended for use with hand drills or drill drivers when cutting through timber, plywood, MDF and similar substrates.

Advantages

The set offers a selection of commonly used diameters to reduce the need for multiple individual tools and to speed up on-site work. Teeth are shaped for efficient cutting in wood and composites to provide consistent hole edges and reduced splintering. Lightweight, removable saw cups and an included pilot drill bit permit quick changes and accurate centring. The product is delivered as a complete kit to simplify selection for carpentry and installation tasks.

Suitable for

• Creating door and lock openings in wooden doors and frames
• Cutting holes for cable grommets and ducting in carpentry work
• Installing recessed fittings, escutcheons and pipe penetrations
• General woodwork and joinery where round cutouts are required

Key specifications

• Material compatibility: wood, plywood, MDF and non-metallic composite boards
• Set contents: 12 hole saw cups covering a range of diameters for typical installation tasks
• Attachment type: compatible with standard drill chucks and common arbor systems
• Cutting edge: toothed saw cups optimised for fast cutting in non-metallic substrates
• Includes pilot drill bit(s) for precise centring and starter drilling

How to use

Select the correct diameter from the set for the required opening and fit the corresponding saw cup to a compatible arbor or directly into a drill chuck if applicable. Secure the pilot bit and ensure the workpiece is firmly clamped to prevent movement. Start drilling at low speed to establish the pilot hole and then increase speed while applying steady, moderate pressure. Withdraw periodically to clear waste material and avoid overheating. After cutting, remove the saw cup and clean the teeth and arbor before storing.

Usage recommendations

Use proper personal protective equipment such as safety glasses and hearing protection. For best results on veneered or laminated surfaces, support the underside of the cut to minimise splintering. Match drill speed and feed rate to the material density and allow the saw to do the cutting to extend tool life.