Twin coaxial cable OEM N male to SMA male 5 m CC-NM-SM-5-D

Twin coaxial cable OEM N male to SMA male 5 m CC-NM-SM-5-D is a 5‑metre twin‑line RF cable assembly with an OEM N male connector on one end and an SMA male connector on the other. It provides two parallel coaxial lines inside a single outer jacket, designed to carry RF signals between equipment that uses N and SMA interfaces. The cable is intended for installations that require matched or paired runs, tidy routing of two signals, antenna connections, test setups and general communications equipment interconnects.

Advantages

The twin coaxial design consolidates two matched signal lines into a single assembly, simplifying cable management and reducing clutter in installations. The fixed combination of an OEM N male connector and an SMA male connector allows direct connection between devices with those interfaces without additional adapters. A 5‑metre length offers a balance between reach and loss for many indoor and sheltered outdoor applications, and the construction maintains consistent electrical characteristics for paired runs.

Suitable for

• Connecting antennas or RF modules with N and SMA interfaces
• Paired signal runs in test benches and laboratory setups
• Linking communications equipment where two matched lines are required
• Extending or adapting equipment connections while keeping wiring organised

Key specifications

• Cable type: twin coaxial assembly with two parallel coax lines in one jacket
• Connector A: OEM N male
• Connector B: SMA male
• Length: 5 metres
• Intended use: RF signal transmission between N and SMA interfaces

How to use

Identify the N and SMA ports on the equipment to be linked and align the corresponding connectors. Hand‑tighten the SMA and N connectors to ensure proper seating; use a torque wrench only if required by the equipment manufacturer to avoid over‑tightening. Route the twin coaxial cable to avoid sharp bends and points of mechanical stress; maintain the cable bend radius recommended for coaxial assemblies. When installing outdoors or in exposed areas, protect the connectors and cable from moisture and mechanical damage with appropriate sealing or conduit.

Usage recommendations

For reliable RF performance, keep cable length as short as practical for the application, avoid kinks and excessive bending, and verify connector cleanliness before mating. If the installation requires weatherproofing, use suitable sealing boots or connector protection for outdoor exposures. When consistent phase and amplitude between the two lines matter, ensure both lines are routed together and subject to the same environmental conditions.