Clamp meter HT200B digital multimeter, AC/DC 600V, current measurement

The HT200B digital clamp meter is a handheld measuring instrument designed to measure AC and DC voltage up to 600 V and to measure electrical current using clamp jaws. Its clamp design enables non-contact current measurement, allowing technicians and electricians to check currents in conductors without breaking the circuit. The compact form factor and clear display make the device suitable for field service, installation checks and routine maintenance tasks where quick, safe readings are required.

Advantages

The clamp jaws provide safe, non-invasive current measurement while the meter also measures AC and DC voltages up to 600 V. The instrument is portable and lightweight, with an ergonomic housing that supports one-handed operation. A clear digital display and straightforward controls simplify measurement setup and reduce the chance of user error. The device is built for practical on-site troubleshooting and routine verification of electrical systems.

Suitable for (tasks / use cases)

• Measuring AC and DC voltage in residential and commercial installations
• Checking current in single conductors without disconnecting circuits
• Troubleshooting motors, HVAC equipment and control circuits
• Routine maintenance and inspection of electrical panels and distribution
• Portable field diagnostics for electricians and service technicians

Key specifications

• Voltage measurement range: AC and DC up to 600 V
• Current measurement method: clamp jaws for non-contact current reading
• Form factor: handheld, portable design suitable for one-handed use
• Display: digital readout for numerical values
• Safety emphasis: designed to minimize direct conductor contact during current measurement

How to use

Turn the meter on and set the function to the required measurement mode (voltage or current). For voltage measurements, place the test leads on the circuit points following standard safety procedures. For current measurements, open the clamp jaws and enclose a single conductor within the jaws without contacting other conductors. Read the measured value on the display and, when finished, power off the instrument and store it in a safe location. Always follow local electrical safety practices and use appropriate personal protective equipment.

Usage recommendations

Use the clamp meter for quick diagnostic checks and routine inspections; avoid exposing the instrument to moisture, extreme temperatures or mechanical shock. Verify the selected measurement mode before applying the meter to a live circuit and ensure only one conductor is inside the clamp jaws during current measurement to obtain accurate readings.