8‑pole DIN cable Omnitronic 30209160, 3 m length

Omnitronic 30209160 is an 8-pole DIN cable with a 3 m length designed for reliable wired connections between audio and control devices that use standard 8-pin DIN connectors. The cable provides a shielded physical link intended for signal transmission in studio, stage and AV installations where a secure fixed connection is required. Its standard 8‑pole DIN terminations make it compatible with a range of mixers, controllers, tape machines and other equipment that accept the 8-pin DIN format.

Advantages

The cable combines a standardized 8-pole DIN connector interface with a three-meter length that balances reach and manageability. Its construction includes shielding to reduce electromagnetic interference and preserve signal integrity over the run. Durable connector housings and a flexible outer jacket are intended to withstand repeated handling in professional environments, while maintaining consistent contact and electrical continuity.

Suitable for

• Connecting audio equipment with 8-pin DIN sockets in studio setups
• Linking control devices and legacy audio gear in live sound rigs
• Fixed AV installations where a shielded, reliable cable run is required
• Signal connections between mixers, processors and tape or interface units using 8‑pole DIN

Key specifications

• Connector type: 8-pole DIN (standard 8-pin DIN mating interfaces)
• Cable length: 3 m
• Shielding: braided/shielded construction for reduced interference
• Outer jacket: flexible PVC or similar material for durability and handling
• Typical use: audio and control signal transmission

How to use

Match the 8-pin DIN connector orientation to the device sockets and insert firmly until the connector seats. Use the cable to route audio or control signals between compatible devices, avoiding tight bends or sharp kinks that could damage the conductors or shielding. For permanent installations, secure the cable along its run with appropriate clamps or cable ties, leaving some slack at connection points to prevent strain on the connectors. Disconnect by grasping the connector housing rather than pulling the cable jacket.

Usage recommendations

For optimal signal quality, keep the cable away from mains power cables and large electromagnetic sources. Inspect connectors periodically for corrosion or debris and replace the cable if the jacket or shielding is visibly damaged. Select the 3 m length where short to medium runs are needed; for longer distances consider using appropriately rated cables or signal distribution methods.