Electromechanical Doorbell ORNO STANDARD BIS single-tone 230V white (wall-mounted)

The Electromechanical Doorbell ORNO STANDARD BIS single-tone 230V white (wall-mounted) is a wired, mains-powered door chime designed for domestic and small commercial entrances. The unit features a white plastic casing with a wall-mounted form factor and uses a simple electromagnet mechanism to produce a single clear tone when energized from a 230V supply. The design emphasizes straightforward installation, reliable operation and compatibility with standard wired door circuits in apartments, offices and small businesses.

Advantages

This electromechanical doorbell delivers a consistent single-tone chime with low power requirements and minimal electronic complexity, which reduces failure modes and simplifies maintenance. The wall-mounted casing in white offers a neutral visual presence that integrates into most interior settings. As a mains-operated device it removes the need for batteries and provides continuous readiness while the electromechanical mechanism ensures a tactile, audible signal with straightforward wiring connections.

Suitable for

• Apartment entry doors and corridors
• Office entrances and reception areas
• Small retail premises and service counters
• Replacement of older wired doorbells in homes or commercial spaces

Key specifications

• Power supply: 230 V AC mains
• Sound output: single-tone chime produced by an electromagnet mechanism
• Mounting type: wall-mounted casing
• Finish: white plastic housing
• Application: wired doorbell systems for domestic and small commercial use

How to use

Mount the doorbell casing on a solid wall surface near the entrance at a convenient height, following local electrical regulations. Connect the unit to a 230 V AC circuit using the appropriate wiring and protective devices; ensure power is switched off during installation. Wire the door push-button switch and any required supply conductors to the terminal points inside the casing according to the wiring diagram supplied with the product. After wiring, restore power and test the chime by pressing the door push-button to verify a single-tone response. For safety and compliance, consider using a qualified electrician for installation if you are not experienced with mains electrical work.

Usage recommendations

For reliable operation and safety, install the doorbell in dry indoor locations protected from direct moisture and extreme temperatures. Regularly inspect mounting and wiring connections and keep the housing free of dust. When replacing an existing bell, verify compatibility with the existing wiring and circuit protection to avoid overloads or improper connections.