Insulated copper ferrule ORNO OR-KK-8100/10/12/B2 — max conductor 10 mm², copper sleeve length 12 mm, pack of 25

Insulated copper ferrule ORNO OR-KK-8100/10/12/B2 is designed for terminating stranded conductors with a maximum cross-section of 10 mm². The component combines a 12 mm copper sleeve and an insulating collar to ensure a reliable crimp connection and enhanced electrical insulation at the termination point. Supplied in a pack of 25, this ferrule is intended for use in electrical installations, control panels, distribution blocks and general wiring tasks where solid, repeatable crimped terminations are required.

Advantages

The copper sleeve offers good conductivity and mechanical strength for stable electrical contact, while the insulating collar reduces the risk of short circuits and provides strain relief at the exposed conductor end. The uniform sleeve length supports consistent crimping quality across multiple terminations. The ferrule's design is compatible with standard crimping tools and facilitates neat, compact terminations suitable for terminal blocks and screw connections.

Suitable for

• Termination of multi-stranded conductors up to 10 mm² cross-section
• Electrical installations and building wiring
• Control panels, distribution blocks and terminal strips
• Industrial and maintenance wiring where secure crimped joints are required

Key specifications

• Conductor compatibility: up to 10 mm² stranded conductors
• Sleeve material: copper
• Sleeve length: 12 mm
• Insulation: insulating collar for improved electrical safety
• Pack quantity: 25 pieces

How to use

Strip the conductor insulation to the appropriate length so that all strands enter the copper sleeve without exposed strands outside the collar. Insert the stripped conductor fully into the ferrule sleeve and position the insulating collar against the cable insulation. Use a suitable crimping tool sized for the ferrule and conductor cross-section to apply a firm, even crimp. After crimping, inspect the termination to ensure a secure mechanical and electrical connection and that the insulating collar sits flush with the cable insulation.

Usage recommendations

Use this ferrule with compatible insulated stranded cables and a properly sized crimping tool. Avoid using on solid conductors or on conductors exceeding the stated cross-section. For reliable results, follow relevant wiring standards and perform a pull test after crimping when required by local regulations or quality procedures.