Perfexim angled mesh water filter 2" (03-060-0500-000) for pipelines

The Perfexim angled mesh water filter 2" is a pipeline strainer designed to remove coarse particles and debris from water flow. Installed at an angle in the pipe run, this filter uses a mesh insert that can be cleaned or replaced to maintain hydraulic performance and protect downstream equipment. The unit is intended for domestic and light industrial installations where protecting valves, pumps and appliances from sediment and larger particles reduces maintenance and risk of clogging.

Advantages

The angled design enables easier access for cleaning and reduces pressure drop compared with some inline strainers. The mesh insert captures sand, scale and other coarse solids while allowing continuous flow. The filter housing and connection standardization simplify installation into existing 2" pipeline layouts. Because the mesh can be removed and either cleaned or replaced, the unit supports long-term operation with periodic maintenance rather than frequent replacements.

Suitable for

• Protection of pumps and centrifugal equipment from sediment
• Pre-filtration ahead of valves and control devices
• Domestic water supply lines and utility circuits
• Light industrial and commercial water systems

Key specifications

• Connection size: 2" (angled orientation for ease of maintenance)
• Filtration element: removable mesh strainer for coarse particle capture
• Installation position: inline with angled body to facilitate cleaning
• Materials: corrosion-resistant housing and mesh suitable for potable and non-potable water systems
• Maintenance: serviceable without full pipe disassembly; mesh can be cleaned or replaced

How to use

Install the Perfexim angled mesh filter in the pipeline using standard 2" fittings, ensuring correct flow direction through the strainer. When installed at the recommended orientation, access the removable mesh insert via the housing cover for inspection. Isolate the section of piping, relieve pressure and remove the cover to extract the mesh. Clean the mesh with water or an appropriate brush, or replace it if damaged or excessively worn, then reassemble and restore system pressure. Follow local plumbing codes for installation and safety procedures.

Usage recommendations

Inspect the mesh periodically based on water quality and operating hours; heavier sediment loads require more frequent checks. Use compatible replacement mesh elements to maintain filtration efficiency. For systems with fine suspended solids, consider supplementary finer filtration downstream.