Carbon motor brushes Philips YSG044 — replacement electrografite brushes for electric motors

Replacement electrografite motor brushes Philips YSG044 are designed to restore electrical contact and consistent performance in commutator-driven electric motors and power tools. These carbon motor brushes provide a conductive, wear-compensating interface between the rotating commutator and the stationary brush holder, helping to maintain efficient current transfer and reduce sparking when properly matched to the motor. They are intended for maintenance and repair tasks where worn or damaged brushes have led to reduced power, intermittent operation, or increased noise.

Advantages

Electrografite construction offers stable electrical conductivity and reduced friction against the commutator surface, supporting steady motor operation over prolonged use. The brushes are formed to provide predictable wear characteristics and consistent contact pressure, which can help extend the life of the commutator and other motor components when replaced in a timely manner. Their design facilitates straightforward installation into standard brush holders used in compatible motors and hand-held tools.

Suitable for

• Replacement of worn carbon brushes in commutator-based electric motors
• Maintenance and repair of power tools such as drills, grinders and saws that use brush-type motors
• Workshop and industrial equipment requiring periodic brush exchange to restore performance

Key specifications

• Material: electrografite (carbon-graphite composite)
• Function: electrical contact and wear compensation for commutator motors
• Typical applications: handheld power tools, small electric motors, workshop machinery
• Design features: pre-formed contact face for stable commutator engagement

How to use

Turn off and disconnect the equipment from power before inspecting or replacing brushes. Access the brush holder according to the motor or tool manufacturer’s instructions, remove the old brushes and inspect the commutator for wear or damage. Insert the replacement electrografite brushes into the holder ensuring correct orientation and secure any retaining springs or clips. After reassembly, run the motor under light load to allow the new brushes to seat properly and to check for correct operation and minimal sparking.

Usage recommendations

Replace both brushes on the same motor at the same time to ensure balanced contact and reduce uneven wear. Inspect the commutator surface and clean or machine it if necessary before installing new brushes. Follow the motor or tool manufacturer’s service intervals and safety guidelines when performing maintenance.