Speaker cable PREMIUMCORD kjpr-02-10, 2x2.5 mm², 10 m length

PREMIUMCORD kjpr-02-10 is a 10 m speaker cable with two conductors, each with a 2.5 mm² cross-sectional area. It is intended for connecting loudspeakers to amplifiers in home or commercial audio systems and supports transmission of audio signals in the 20 Hz–20 kHz range. The cable has transparent insulation and is sized for music power up to 100 W over the 10 m length.

Advantages

The cable uses 100% copper conductors for reliable electrical conductivity. Two 2.5 mm² conductors provide sufficient current capacity for medium-power speaker systems, while the transparent insulation allows visual inspection of the conductors. The 10 m length is convenient for in-room speaker runs and simple installations with banana plugs or bare-wire terminations.

Suitable for

• Connecting passive loudspeakers to amplifiers in home stereo systems
• Short to medium in-room speaker runs (up to 10 m)
• Multiroom or commercial audio setups with medium-power requirements

Key specifications

• Brand: PREMIUMCORD
• MPN: kjpr-02-10
• Length: 10 m
• Conductors: 2
• Conductor cross-section: 2.5 mm² each
• Conductor material: 100% copper
• Insulation: transparent
• Frequency range: 20 Hz–20 kHz
• Recommended power: up to 100 W (for 10 m run)
• EAN: 8592220014988

How to use

Strip the insulation from the conductor ends to the required length, taking care not to damage the copper strands. Terminate the cable with banana plugs, spade connectors or by making bare-wire connections to speaker and amplifier binding posts. Ensure correct polarity (positive to positive, negative to negative) to maintain proper speaker phase. Route the cable to avoid sharp bends, heat sources and mechanical strain.

Usage recommendations

For best results, keep runs as short as practical and avoid parallel routing alongside mains power cables to reduce interference. For higher power or longer distances, consider a cable with a larger conductor cross-section.