Instrument cable Procab jack-to-jack 3 m — 6.35 mm TS instrument lead

Procab jack-to-jack instrument cable, 3 m long, equipped with 6.35 mm (1/4") TS mono connectors for connecting electric guitars, basses, keyboards and other unbalanced instrument outputs to amplifiers, effect pedals and audio interfaces. The cable is designed for reliable signal transfer of mono instrument-level signals and is suitable for rehearsals, rehearsal rooms, live stages and studio sessions. Its durable build addresses frequent handling and routine cable movement.

Advantages

The cable delivers straightforward, low-complexity mono signal transmission through standard 6.35 mm TS connectors. Its 3 m length balances reach and manageability, allowing flexible placement between player and amplifier or pedalboard. The jacket and connection points are constructed to withstand repeated plugging and unplugging, reducing the risk of intermittent contact. The simple, unbalanced design is compatible with common instrument outputs and offers consistent performance for practice, live sound and recording setups.

Suitable for

• Connecting electric guitars and basses to amplifiers
• Linking keyboards and mono instrument outputs to effect pedals and interfaces
• Stage use where moderate cable length and reliable connections are required
• Rehearsal rooms and home studios for instrument signal routing

Key specifications

• Connector type: 6.35 mm (1/4") TS mono jack to TS mono jack
• Length: 3 metres
• Cable topology: unbalanced, single-channel instrument cable
• Intended signal type: instrument-level mono signals
• Construction: flexible jacket with reinforced connector ends for frequent handling

How to use

Insert one 6.35 mm TS connector into the instrument output jack and the other into the input of an amplifier, pedal or audio interface. Ensure connectors are fully seated to avoid crackling or signal loss. Route the cable to avoid tight bends and sharp kinks; coil excess length loosely to prevent stress on connectors. For stage setups, secure the cable to the floor or pedalboard to reduce trip hazards and accidental disconnection.

Usage recommendations

For best results, keep connectors clean and dry and avoid pulling the cable by the cord when unplugging; instead, grasp the connector body. Store the cable coiled without tight loops and inspect connector contacts periodically. When used with pedals or high-gain amplifiers, position gain controls and pedals appropriately to reduce hum typical of unbalanced instrument cabling.