Cable Tester Procab TST200 — multifunctional transmitter and receiver for cable continuity and routing

Procab TST200 is a multifunctional cable tester that combines a transmitter and receiver to verify cable continuity, wiring pairs and routing. Designed for installers and technicians, the device checks signal presence, identifies pairs and detects open or short faults on patch, network and audio/video cabling. The compact, portable format and straightforward controls make the Procab TST200 suitable for on-site diagnostics and routine maintenance of communication and multimedia installations.

Advantages

The Procab TST200 provides both transmitter and receiver functions in a single unit, enabling rapid verification of cable continuity and pair mapping without needing multiple tools. Its simple control layout supports quick setup and one-handed operation, while clear indication of faults helps reduce troubleshooting time. The tester supports a range of common cable types used in patching, network and audio/video systems, and its portable design is convenient for field technicians.

Suitable for

• Testing continuity and wiring of Ethernet twisted-pair (patch) cables
• Verifying audio/video cabling and signal routing
• Identifying cable pairs and performing basic pair tracing
• Detecting open circuits and short circuits in installed cabling
• On-site maintenance checks and quick diagnostics by installers and technicians

When it may not be suitable

The Procab TST200 is intended for basic continuity, pair identification and routing tests and may not be suitable for advanced network certification or performance benchmarking where parameters like insertion loss, return loss, crosstalk or bandwidth verification are required. For environments requiring detailed certification reports or compliance to specific industry cabling standards, a dedicated network certifier should be used.

Key specifications

• Functionality: combined transmitter and receiver for continuity, pair identification and routing
• Supported cable types: patch cables, Ethernet twisted-pair, and common audio/video cables
• Fault detection: open circuit and short circuit identification
• Form factor: portable handheld unit suitable for field use
• User interface: simple controls for quick operation and indicators for pair mapping and fault status

How to use

Connect the transmitter to one end of the cable under test and attach the receiver to the other end or use the receiver to probe along the cable route for pair tracing. Power the units according to the manufacturer instructions, select the required test mode and observe the indicator outputs on the receiver to determine continuity, pair identity or presence of a short. Move along the cable route as needed to locate breaks or incorrect wiring and re-test after repairs to confirm restoration of continuity.

What to consider before purchase

• Verify that the device supports the cable types you will test (Ethernet, patch, audio/video)
• Consider whether you need basic continuity and pair tracing or full network certification capabilities
• Assess portability and battery/power requirements for field use

Usage recommendations

Use the Procab TST200 as part of routine installation checks and troubleshooting workflows: start with continuity and pair mapping, then isolate and repair any open or short faults, and re-test to confirm correct wiring. For critical installations, complement the TST200 checks with full certification tools when performance metrics are required.