Angle grinder accessory Proline 44814 — 12.5 cm diameter, single piece

Replacement accessory for angle grinders by Proline, model 44814, with a 12.5 cm (125 mm) diameter supplied as a single piece. This accessory is designed to mount on compatible handheld angle grinders and is intended for cutting, grinding or surface removal tasks depending on the specific disc or wheel fitted. Flap discs are made from abrasive linen with corundum grain, evenly applied on a glass fibre body, providing a balance between material removal and surface finish for both DIY and professional applications.

Advantages

The Proline accessory combines an abrasive linen layer with corundum grit for consistent cutting and grinding performance, while the glass fibre body adds dimensional stability and resistance to deformation during use. Its 12.5 cm diameter matches common 125 mm grinder fittings, ensuring compatibility with a wide range of handheld angle grinders. Supplied as a single piece, it is simple to handle and replace when needed.

Suitable for

• Machining edges and seams on stainless steel and steel sheets
• Surface preparation and finish on aluminum, brass and bronze
• Material removal and shaping on wood and plastic
• Paint and lacquer removal or surface smoothening

Key specifications

• Diameter: 12.5 cm (125 mm)
• Quantity: single piece per pack
• Abrasive material: linen with corundum grain
• Disc backing/body: glass fibre
• Intended use: cutting, grinding, surface removal depending on disc type

How to use

Mount the accessory on an angle grinder compatible with 125 mm discs, following the tool manufacturer's mounting and safety instructions. Ensure the grinder is switched off and unplugged or the battery removed before fitting. Secure the disc according to the grinder's flange and spindle requirements, check for run-out and ensure the disc rotates freely without obstruction before powering the tool. Use appropriate speed ranges and apply consistent, moderate pressure; avoid forcing the disc to prevent excessive wear or damage.

Usage recommendations

Wear suitable personal protective equipment including eye protection, gloves and hearing protection. Choose the correct disc type and grit for the material and task: coarser grits for faster material removal, finer grits for finishing. Maintain steady motion to avoid overheating the workpiece and allow the abrasive linen with corundum grain to do the cutting. Inspect the disc for damage before each use and replace if any cracks, excessive wear or delamination are present.