Angle grinder accessory Proline 44851 — grinding/cutting disc Ø11.5 cm, 1 pc

Proline 44851 is an angle grinder accessory — a single 11.5 cm grinding and cutting disc supplied as one piece per pack. The disc is a zirconia flap type intended for use with compatible angle grinders and is suitable for light cutting, grinding and surface finishing tasks on steel, stainless steel, acid-resistant steels and non-ferrous metals, as well as for general metalworking where a compact 115 mm disc is required.

Advantages

The zirconia flap construction provides a balance of cutting speed and abrasive life, allowing efficient material removal and consistent surface finish. The compact 11.5 cm diameter enables work in tighter spaces and better control on thin or small components. Supplied as a single unit, the disc is easy to replace and store, and its design is suitable for a range of metalworking tasks with compatible angle grinders.

Suitable for

• Light cutting of steel and non-ferrous metals
• Grinding and deburring welds and edges
• Surface finishing on stainless and acid‑resistant steels
• Working in confined spaces or on small components

Key specifications

• Disc type: zirconia flap grinding/cutting disc
• Diameter: 11.5 cm (115 mm)
• Pack quantity: 1 piece
• Intended materials: steel, stainless steel, acid‑resistant steel, non‑ferrous metals
• Primary applications: cutting, grinding, surface finishing

How to use

Install the disc on a compatible angle grinder following the tool manufacturer's instructions and ensure the grinder is unplugged or the battery is removed during fitting. Use appropriate flange and secure mounting; check that the disc rotates freely without wobble before powering the tool. Operate the angle grinder at the recommended speed range for the disc and apply steady, controlled pressure while moving the disc across the workpiece. Allow the abrasive to do the work rather than forcing the disc to avoid overheating and premature wear.

Usage recommendations

Always use appropriate personal protective equipment: safety goggles or a full face shield, hearing protection, gloves and protective clothing. Ensure adequate ventilation and a secure workpiece. Match disc speed rating with your angle grinder and avoid side pressure beyond the disc's intended use. Store the disc flat, dry and away from extreme temperatures.